CP-6-series Mechanical Reference - 第137页

Part 3 Chapter 3 Replacing Consumable Parts Edition 1.6 3-3-6 CP-6-series Mechanical Reference 3.4 Replacing the W aste T ape Cutter Point If waste tape is not being cut properly, tape feed may jam. In such cases, replac…

Part 3 Chapter 3 Replacing Consumable Parts

Edition 1.6 3-3-5 CP-6-series Mechanical Reference

3.3 Vision Processing UV Lamp Replacement

Point

Oil from the skin may weaken the glass over time, reducing its lifespan.

Procedure

Warning

Turn off the main power before carrying out this work.

Remove the UV lamp by turning it and pulling it out.

Note : Avoid direct contact with the glass.

UV lamp

CP6M3058

Part 3 Chapter 3 Replacing Consumable Parts

Edition 1.6 3-3-6 CP-6-series Mechanical Reference

3.4 Replacing the Waste Tape Cutter

Point

If waste tape is not being cut properly, tape feed may jam. In such cases, replace the

waste tape cutter.

Procedure

Warning

• Turn off the main power before carrying out this work.

• Exercise extreme caution when working on the machine if the cam is

not at its origin (0 deg.). Recoil of the cam axis can endanger the

operator.

Remove the cutter by unscrewing the two bolts on the moving and two bolts on the fixed

cutter. Put in a new cutter and re-tighten the two bolts.

Movable blade

Fixed blade

CP6M3059

Part 3 Chapter 3 Replacing Consumable Parts

Edition 1.6 3-3-7 CP-6-series Mechanical Reference

3.5 Conveyor Belt Replacement

Point

Replace the board conveyor belt if it becomes cut or otherwise damaged.

Procedure

Warning

Turn off the 200 V servo power before carrying out this work.

1. Remove the motor cover.

2. Loosen the fixed bolt on the tension pulley to loosen the belt tension.

3. Loosen the belt guide bolts.

4. Replace the belt.

5. Insert a 0.3 mm filler gauge between the plate and the top of the belt, and tighten

the guide belt bolts, while maintaining this 0.3 mm gap.

6. Adjust the strength of the pulley tension to 1 to 1.5 kg, and tighten the tension

pulley bolts. Refer to the arrows in figure above for the direction in which the

tension pulley should be moved to increase the tension. If possible, use a tension

gauge to confirm the 1 to 1.5 kg while fixing the tension pulley. If a tension gauge

is not used, tighten the tension pulley bolts while pressing the tension pulley 1 to 2

mm, when the belt does not have any slack. (1 to 1.5 kg for the pulley strength is

approximately 1 to 2 mm.)

Motor cover

Tension pulley

Belt guide bolt

CP6M3060