CP-6-series Mechanical Reference - 第159页

Edition 1.3 4-5-1 CP-6-series Mechanical Reference Part 4 Chapter 5 Electric Power Supply 5. Electric Power Supply Power Consumption CP-6 : approximately 8.5 KVA CP-6M, CP-642, CP-642M, CP-643E, CP-643ME, CP-65 : approxi…

Part 4 Chapter 4 Checking the Transformer Connections

Edition 1.0 4-4-2 CP-6-series Mechanical Reference

Notes:

Edition 1.3 4-5-1 CP-6-series Mechanical Reference

Part 4 Chapter 5 Electric Power Supply

5. Electric Power Supply

Power Consumption

CP-6 : approximately 8.5 KVA

CP-6M, CP-642, CP-642M, CP-643E, CP-643ME, CP-65 : approximately 10.0 KVA

CP-652C : approximately 20.3 KVA

(Capacity of transformer)

Connect the machine to a power supply with a capacity more than specified above.

Voltage

The CP-6 series contains a multiple input transformer which allows the machine to be

used with the normal supply voltage in any country.

Before connecting the power supply to the machine, make sure that the transformer tap

position matches the actual voltage to be supplied to the machine.

(The transformer is normally set correctly for the destination country before the machine

is shipped from the Fuji factory.)

Power Supply Cable

Use a power supply cable with at least 22 mm

. (Power supply of 200~230 V)

Thin cables may overheat or cause drop in the supply voltage.

Part 4 Chapter 5 Electric Power Supply

Edition 1.3 4-5-2 CP-6-series Mechanical Reference

Connecting the Power Supply

DANGER

Verify that the external power supply is off before

performing this procedure.

1. Open the power box, then remove the transparent terminal cover.

2. Feed the power cable into the power box from the power cable inlet located at the

left side of the power box.

3. Connect the ground cable to the dedicated ground terminal.

4. Connect the 3-phase cable to the main breaker and tighten to the prescribed

torque.

Terminal screw tightening torque: 5.8 N⋅m (58 kgf⋅cm)

Note: Terminal screws should be tightened periodically.

5. After connecting the cable, secure it with the cable lock nut located at the power

cable inlet.

Cable lock nut tightening torque: 7.5 N⋅m (75 kgf⋅cm)

Power box

CP6MS026E

Three-phase

electric wire

Power cable

Cable lock nut

Ground cable

Transparent

terminal cover

20 mm

Main breaker

Terminal screw

Recommended driver

8.0 mm 1.0 mm

Main breaker