CP-6-series Mechanical Reference - 第249页

Notes: Part 7 Chapter 2 Placement Accuracy Measurement Edition 1.0 7-2-14 CP-6-series Mechanical Reference

2.8.2 Procedure at PC

Setting the Communication Conditions

1. At the PC side, connect the transmission cable (machine <—> NTCC) to the port

which is not being used by NTCC. If there are no vacant ports, leave the cable as it

is, and end NTCC. (When NTCC is ended, acquisition of production information

from other machines is disabled.)

2. When using Windows NT 3.51

i) Start up the communication software at the PC as follows: “Program

Manager” —> “Accessories” —> “Terminal”.

ii) At the Terminal menu, select “Settings” —> “Communication Conditions”,

then specify the following settings:

Communication speed (bps): 9600

Flow control: Xon/off

Serial port: COM?

(PC port connected to transmission cable)

Data length: 8

Stop bit: 1

Parity: None

iii) At the menu, select [File] —> [Save As] to save the setting conditions. Once

saved, these settings are convenient when using the trace port (e.g.

trace.trm).

3. When using Windows NT 4.0

i) Click the START button, select “Accessories”, then start up the Hyper

Terminal.

ii) Enter the name (e.g., trace) at the connection settings, select the icon, then

click OK.

iii) Select the PC port (COM?) where the transmission cable is connected, then

click OK.

iv) At the port settings, specify the same settings as those at 2-ii) above, then

click OK.

v) At the menu, select [File] —> [Save] to save the setting conditions. A

shortcut is created at the START button (e.g. trace.ht).

Part 7 Chapter 2 Placement Accuracy Measurement

Edition 1.0 7-2-13 CP-6-series Mechanical Reference

Notes:

Part 7 Chapter 2 Placement Accuracy Measurement

Edition 1.0 7-2-14 CP-6-series Mechanical Reference

Part 8

Pallet Feeder

- CP-652CE Only -