PS288_PS388_PS588_981-0424-002D - 第88页

Operation ■ Operator Functions 3—18 Data I/O • 981-0424-002 back Figure 3-20: The SETUP Window requires input, output, and reject selections (box ed here) on the Option s tab. Only option s set in the WinAH400.ini file w…

■ Operator Functions ◘ Running a Job on PS Systems

PS Series Owner’s Manual 3—17

back

Figure 3-19: Tube Input and Output are selected here. (Vibrator

input/output are Tubes.) Common setups will not display all the

optional features shown here. The left image shows the ICOS

inspection System settings.

1e. [Laser Marking System only] Turn the Laser Marker On (green)

or Off (red).

1f. [Label Marking only] Turn the Labeling toggle On (green) or Off

(red).

1g. [If the ICOS Inspection System is installed] the settings will

appear as shown in the image on the left side of Figure 3-19

above. It can be turned On or Off with the toggle switch. The

Comp-ID number defines the inspection job and is read from the

PS System Package file. The two check boxes below it allow

selecting when to inspect the devices. Both can be selected.

Operation ■ Operator Functions

3—18 Data I/O • 981-0424-002

back

Figure 3-20: The SETUP Window requires input, output, and reject

selections (boxed here) on the Options tab. Only options set in the

WinAH400.ini file will display. Common setups will not display all the

optional features shown here.

Enhanced Yield Programming

1h. (Optional) In the Continuity Retries field, enter the number of

times the system should retry continuity failures before rejecting

the device.

1i. (Optional) In the Fail Retries field, enter the number of times the

system should retry programming failures (excluding over-cur-

rent and continuity) before rejecting the device.

1j. [Automotive Performance Pak only] Optional: Start any of the

five utilities available with the AP Pak.

1k. If Ignore Programmers is On (green), the PNP head will not stop

at the programmers and will effectively transfer devices from

input media to output media with no programming, and with or

without laser marking. The default is Off.

Note: Only installed options are available for selection on the

Options tab. If different input media (tube, tape, or tray) is desired,

For more information on

the AP Pak, see the AH500

online Help.

■ Operator Functions ◘ Running a Job on PS Systems

PS Series Owner’s Manual 3—19

back

the winAH400.ini file may need to be edited. See the online Help for

instructions editing the WinAH400.int file or contact Data I/O

support or an authorized technician.

2. Verifying—

2a. At the Setup Window, click the Job Info tab.

2b. Verify that all the information displayed for this job is accurate.

See Figure 3-21 below.

Figure 3-21: The Job Info Tab is a read-only review of information, with

the exception of the Pass Limit field, which is editable.

3. (Optional) Change the Pass Limit —

3a. On the Job Info tab, click the in Pass Limit field and enter the new

Pass Limit value and click OK.