[Superset] Chapter5_SPC Plus_ENG_20100827TW - 第48页

Programmer's Manual | 48 3. Once the Production Quantity dialog box is enabled, select DA.Data Clear cat egory . Apply the configured change s above. 3.14.2. P OST - SETUP U SE After  completing  the  Defect  An…

Programmer's Manual | 47

 ToenableordisabletheDefectAn alysis functionwhilerunningtheprogram,proceedwith

thefollowing:

1. Click Setup menu in the sub-menu of 3D Inspector

™

to enable the Zebra Basic Setup dialog box.

Select (or unselect) Defect Analysis category on the mid-left side of Basic tab.

2. From the file menu of 3D Inspector™, select an inspection quantity-assigning menu.

Programmer's Manual | 48

3. Once the Production Quantity dialog box is enabled, select DA.Data Clear category. Apply the

configured changes above.

3.14.2. POST-SETUP USE

AftercompletingtheDefectAnalysisfunctionsettings,theDefectAnalysismenuisgeneratedatthe

lowerrightsidewhen3DInspector

™

isexecuted.Thedefectaccumulationcanbecheckedinthe

chart on the screen shown below; clicking parts other than the chart bar connects to RealDefect

TrendViewofSPCPlus

™

.

Programmer's Manual | 49

3.14.2.1. Real Defect Trend Tool

SelectingRealDefectTrendToolfromthesub‐menuofDefectAnalysiscausesthequantityofdefects

ineachboardtobedisp layedasshownbelow.