00198532-01_SM_MeasurementFeeder_EN - 第10页

2 Replacing spare parts 2.2 Front sliding guide / sliding foil 10 Service Manual SIPLACE MeasurementFeeder X 02/2020 2.2.1 Removing the Front Sliding Guide NOTICE The pickup window must be fitted To prevent damage to the…

100%1 / 30
2 Replacing spare parts
2.1 Overview
Service Manual SIPLACE MeasurementFeeder X 02/2020 9
2 Replacing spare parts
2.1 Overview
1. Measurement location with contact plates
2. Protective cover
3. Rear centering pin
4. Carrying handle
5. Status-LED
6. Removal handle
7. Rear sliding guide
8. Calibration module interface
9. Front sliding guide / sliding foil
10. EDIF (Energy and Data Interface)
11. Front centering pin
2.2 Front sliding guide / sliding foil
Required spare parts
Fig.1: Sliding guide and sliding foil
Feeder module Item no. Designation
Measurement-
Feeder X
03058808-Sxx Sliding guide
03019604-Sxx Sliding foil, X-feeder JUM-S-06LY
Required tools
●
Sliding foil remover
●
Phillips screwdriver
2 Replacing spare parts
2.2 Front sliding guide / sliding foil
10 Service Manual SIPLACE MeasurementFeeder X 02/2020
2.2.1 Removing the Front Sliding Guide
NOTICE
The pickup window must be fitted
To prevent damage to the sprocket wheel and the reject device, make sure that the pickup
window is fitted for this work.
► Turn the feeder module so that its underside is at
the top.
► Place the sliding foil remover into the sliding
guide, as shown in the diagram.
► Lever the sliding foil out of the engaged position.
► Lever the sliding foil until it has been turned by
approximately90°.
► Push the sliding foil towards the front and out of
the sliding guide.
► Loosen the 2 screws.
► Lift the sliding guide off the feeder module.
2 Replacing spare parts
2.2 Front sliding guide / sliding foil
Service Manual SIPLACE MeasurementFeeder X 02/2020 11
2.2.2 Fitting the Front Sliding Guide
NOTICE
The pickup window must be fitted
To prevent damage to the sprocket wheel and the reject device, make sure that the pickup
window is fitted for this work.
► Insert the sliding guide - as shown in the diagram
- into the groove on the drive carrier.
► Position the front sliding guide so that you can
see the holes for the screws through the sliding
guide.
► Fix the sliding guide to the feeder module with
the 2 Phillips head screws (M3x10mm).
► Press the sliding foil slightly together.
► Push the sliding foil from the front into the sliding
guide, until it engages audibly.