00198532-01_SM_MeasurementFeeder_EN - 第5页
1 Introduction 1.1 Safety instructions Service Manual SIPLACE MeasurementFeeder X 02/2020 5 1 Introduction 1.1 Safety instructions DANGER Nonobservance of these safety instructions may cause injury to personnel and dam- …
4 Service Manual SIPLACE MeasurementFeeder X 02/2020
Table of contents
1 Introduction
1.1 Safety instructions
Service Manual SIPLACE MeasurementFeeder X 02/2020 5
1 Introduction
1.1 Safety instructions
DANGER
Nonobservance of these safety instructions may cause injury to personnel and dam-
age to the machine!
► Please observe the safety instructions in the user manual of the relevant machine
for all work!
1.1.1 Conventions for the use of safety instructions and symbols
Safety instructions
This manual contains notes that must be observed to guarantee your personal safety and to avoid
damage to equipment. These notes are highlighted by warning triangles and are indicated as fol-
lows according to the level of risk:
DANGER
Definition
For the purposes of this manual, this indicates that fatal or severe injuries or considerable
damage to property will occur if this hazard warning is not observed.
WARNING
Definition
For the purposes of this manual, this indicates that fatal or severe injuries or considerable
damage to equipment may occur if these warning instructions are not followed.
CAUTION
Definition
For the purposes of this manual, this indicates that minor injuries or damage to property
may occur if this caution is not observed.
NOTICE
Definition
For the purposes of this manual, this note provides information about the product or indic-
ates a part of the manual that requires particular attention.
Symbols
Example Description
Next This typeface marks controls and interface elements in the software.
► This symbol indicates actions that have to be performed by the operator.
1.1.2 ESD
CAUTION
Observe the ESD regulations!
When working on the feeder module, pay attention to ESD safety.
Before you open the side cover, make sure you are wearing the ESD protection wristband,
to prevent damage to the highly sensitive boards inside the feeder.
1 Introduction
1.2 Environmentally-friendly disposal of materials and components
6 Service Manual SIPLACE MeasurementFeeder X 02/2020
1.2 Environmentally-friendly disposal of materials and
components
Our products are manufactured using only materials and parts that can be easily separated and
disposed of in an environmentally-friendly way.
NOTICE
Observe the applicable regulations
The company operating the system has sole responsibility for the proper, environmentally-
friendly disposal of machines, working materials, consumable materials and wear parts.
► Please observe your national statutory provisions for waste disposal and environ-
mental protection.
1.3 Use of original accessories and spare parts
Only use original spare parts and authorized accessories. The use of other parts will affect safety
and will invalidate the liability for any consequential damage.
1.4 Requirements
To correctly repair MeasurementFeeder modules, you require an ESD-compatible workplace with a
stable, level and clean surface.
Required tools
●
SIPLACE X Feeder Verification System (FVS), item no. 03126186-xx
●
SIPLACE MeasurementFeeder X Calib. Kit, item no.03220703-01
●
Flat-bladed screwdriver 0.9 Nm
●
Phillips screwdriver 0.9 Nm
●
TORX screwdriver 0.6Nm, size T8
●
Sliding foil remover [03075421-xx]
1.5 Information About This Service Manual
WARNING
Additional qualifications required
The service work described in this manual may only be performed by specially trained per-
sonnel and therefore requires additional qualifications and skills.
Please contact your SIPLACE service team if you have any special questions about service work.