OM-1058-002 - 第16页

Tg0409-PM-SO 0410-002 15 2.1 Attachment of T apes Fig. 21 If the cover tape or the chip component gets caught by the suppressor , then the peeling section might be deformed or a pick- up error occur . If there is any suc…

Tg0409-PM-SO0410-002 14

Fig. 18

(8) Set the carrier tape so that the sprocket

pins are securely engaged with the

sprocket holes.

(a) Make sure there is no foreign substance

on the carrier tape.

If there is any, remove it with a rag or

air gun.

(b) For tape feeder of 32 or 44 mm width,

attach the tape, aligning it with the pins

on the sprockets on the right and left.

(Refer to Fig. 19).

2.1 Attachment of Tapes

If any foreign substance (chip component, dust, debris or fiber) is

left on the carrier tape then a pick-up error might be caused.

Fig. 19 Tape Feeder of 32 or 44 mm Width

Notice

Note

Tg0409-PM-SO0410-002 15

2.1 Attachment of Tapes

Fig. 21

If the cover tape or the chip component gets caught by the

suppressor, then the peeling section might be deformed or a pick-

up error occur.

If there is any such catching of the cover tape or chip component,

do not pull it out forcibly; just lift the suppressor.

(10) Make sure that the cover tape or chip

component is not caught in the peeling

section.

If operation is performed with the

cover tape caught in the

suppressor . . .

It might also cause distortion in the tape

peeling section, or scratches on the cover

tape, which might lead to the tape's being

cut off.

The peeling section might be

deformed.

Suppressor

If the suppressor is lowered with

any foreign substance on the tape

surface . . .

Foreign Substance

Deformation

Cover Tape

Notice

(9) Lower the suppressor carefully.

When the suppressor for the tape feeder

with a tape width of 12 mm or more is to

be set, if such suppressor is forced into

setting while the pin is not aligned with

the U-groove, the suppressor might be

deformed.

Always set the suppressor while the pin

is aligned with the U-groove.

Notice

U-GroovePin

Fig. 20

Tg0409-PM-SO0410-002 16

(12) Attach the suppressor holding lever to

the suppressor hook section.

Slide the suppressor holding lever by press-

ing its lower section.

2.1 Attachment of Tapes

Fig. 22 Attachment of Front Hook

(11) Catch the pin with the front hook.

Slide the hook by pressing its lower section.

Fig. 24 Attachment of Suppressor

Holding Lever

OK NG

Fig. 23 Front Hook Attachment Condition

OK NG

Fig. 25 Suppressor Holding Lever

Attachment Condition (Opposite

Side)

If the tape feeder is used when the front hook and

the suppressor holding lever have come off, the

machine might be damaged or a pick-up error

occur.

Attach the front hook and the suppressor holding lever

correctly.

CAUTION