OM-1058-002 - 第58页
Tg0409-PM-SO 0410-002 57 5.3 Maintenance Method Fig. 84 Apply grease on the section of . T oo much grease might adhere to the rear side of the shutter , and so might cause a pick-up error . : : : Shutter Closed Shu…
Tg0409-PM-SO0410-002 56
5.3 Maintenance Method
Fig. 83
TF-0814 Tape Feeders of
12 mm Width or more
Tape Take-up Link
Fulcrum Pin of Tape Take-up Link
(Only for TF-0814 and tape feeders of
12 mm width or more)
Every month Lubrication
Remove the tape take-up link, apply
New Molynoc Grease No. 1 using a thin bar.
Apply grease from the top.
AA
View A
Tape Take-up Link Selection Section
(Only for TF-0814 and tape feeders of
12 mm width or more)
Every month Lubrication
Remove the tape take-up link, apply
New Molynoc Grease No. 1 using a thin bar.
Do not apply grease where it is
not necessary, dust or fibers might
adhere there and so might cause
a pick-up error.
Notice
Apply grease on the section of .
Note
Tg0409-PM-SO0410-002 57
5.3 Maintenance Method
Fig. 84
Apply grease on the section of .
Too much grease might adhere to the rear side of the shutter, and
so might cause a pick-up error.
:
:
:
Shutter Closed
Shutter Opened
Apply it on the contact surface of the
shutter sliding guide and the shutter base.
Shutter Sliding Guide
Every month Lubrication
Lubricate it, using the following procedure.
1. Drip alcohol on the shutter sliding guide.
2. Air-blow it.
3. With a thin bar, apply Daphne Eponex
Grease No. 1 on the contact surface of
the shutter sliding guide and shutter base.
4. Open the shutter and apply Daphne
Eponex Grease No. 1 between the shutter
sliding guide and the suppressor, with a thin
bar.
5. Move the shutter backward and forward to
create a smooth coating of grease.
Inadequate maintenance of the
shutter section may allow foreign
substances enter, and rust might
cause malfunction.
Notice
Appl
y
it
b
etween the shutter slidin
g
g
uide
and the suppressor.
Notice
Note
Tg0409-PM-SO
5.3.5 Quarterly Maintenance
0410-002 58
5.3 Maintenance Method
Fig. 86
Fig. 85
Table 9
Pick-up Position (Fig. 86)
Feeder Adjusting JigFig. 86 Check,
Adjustment
Pick-up Position
Reference
Drawing
Work Working Tools
Name
Location to be maintained
Check
Pick-up Position
Check and Adjustment Every Three Months
Check the pick-up position, using the feeder
adjusting jig JG-0148.
If the pick-up position is not correct, adjust it.
For details of pick-up position
adjustment, see the Instruction
Manual for the Feeder Adjusting
Jig JG-0148.
The "Work Procedure (3) in 5.3.4
Pick-up Position Adjustment to
Direction Y" is not required.
Reference