YSM20&40_how_to_change_directionPDFA.pdf - 第5页
Service Engineer Service Information SI1407002E - 000 =YSM40_How to change the board flow direction (Tentative measure) 5/ 24 1.2 Remove the slope 1. Remove the air joint . Remove the cover f or the cables and r emove th…
Service Engineer
Service Information
SI1407002E-000=YSM40_How to change the board flow direction (Tentative measure)
4/24
Note:
If the cover that protects the driving part of the tape cutter is the old type, remove the front cover.
Use a T-shaped wrench (M4) to remove the eight (8) screws.
3. Remove the tape cutter duct.
Slide the duct downward and then push it. The duct hook on the far side is detached and the duct
can be removed.
Caution:
If the duct is detached from the hook, it drops by its own weight. Make sure to hold it carefully when
removing the duct so that not to drop it on your foot.
Service Engineer
Service Information
SI1407002E-000=YSM40_How to change the board flow direction (Tentative measure)
5/24
1.2 Remove the slope
1. Remove the air joint.
Remove the cover for the cables and remove the air hose from the joint.
The connection of the joint is fixed to the slope. This is for safety and to prevent the false operation
of the tape cutter after removing the slope.
Figure 2
2. Remove the slope.
Remove the screws and pull the slope upward to detach it.
Caution:
When removing the slope, be careful not to damage the sensor fibers and other wires.
Figure 3
Remove the M4 screws
(M4x20) on the under surface
of the slope. (Qty: 4)
Remove the M4 screws
(M4x6) on the both side of
the slope (Qty: 4)
Remove the air hose attached to the slope
(Orange).
As the joint is fixed to the slope, there is
not enough space to remove the hose.
Use long-nose pliers for the removal.
Service Engineer
Service Information
SI1407002E-000=YSM40_How to change the board flow direction (Tentative measure)
6/24
1.3 Remove the ANC unit
If the machine is equipped with an ANC unit (Option), remove it to create a work space.
1. Remove the chip damp box.
2. Remove the ANC unit
Remove the M6 screws (Qty:2) that secure the ANC unit.
Slide the ANC unit outward and sideways to detach it from the ANC unit base.
Note:
As the terminal connector that the signal wire and the air hoses are connected is attached to the ANC
unit, if you lift it up without detaching it from the ANC unit base, you may break the connector part.
Make sure to slide the terminal connecter to detach it from the ANC unit base and remove it.
* Although you can access to the screws that secure the ANC from above the ANC unit, there is
not enough space. Use a T-shaped wrench to remove the screws.
Figure 4
[The machine without the Slope and the ANC unit]
Remove the slope and the ANC unit from the machine to change the conveyor direction smoothly.
Figure 5