N7201A616E00_0317 - 第138页

NPM-W 2 EJM7DE-MB-02 O-00 2-4-1 -3 Prepara- tions before produc- tion Operating procedure 2-4-1 Pr epar ation of the intelligent f eeder 2 Removing the double tape feeder 2 1 1 2 Lift up the rear side and remove the feed…

100%1 / 714
NPM-W2 EJM7DE-MB-02O-00
2-4-1-2
Preparation
2
1
Installing the thin type tape feeder
Cut the carrier
tape
Attach the feeder to the attachment
Align the feeder edge to the
insertion slot of the dedicated
attachment and insert.
Pull down the lever and insert it
all the way inside.
Confirm that the dedicated attachment has been installed.
2
1
●Refilling the substitution part (→P.3-3-1)
Carrier tape
To step on the left page
3
2
Align the attachment edge to
the slot and insert
Pull up the lever and insert
all the way inside
1
1
2
■How to attach the dedicated attachment
■How to attach the thin type tape feeder
NPM-W2 EJM7DE-MB-02O-00
2-4-1-3
Prepara-
tions
before
produc-
tion
Operating procedure
2-4-1
Preparation of the
intelligent feeder 2
Removing the double tape feeder
2
1
1
2
Lift up the rear
side and remove
the feeder with
both hands
Pull up the lever
and pull out the
feeder
How to hold the feeder
Hold the parts with
both hands
Batch exchange using the feeder cart (option)
Pay attention to your surroundings when you move the feeder
cart
(Risk of injury in a collision with the cart )
WARNING
Setting up production feeders on the spare feeder cart in advance allows you to replace the feeders by one
operation during a changeover. (→[Maintenance] P.3-2)
NPM-W2 EJM7DE-MB-02O-00
2-4-1-4
Preparation
Removing the thin type tape feeder
2
Remove it from
the dedicated
attachment
1
Pull out the
feeder
How to hold the feeder
Hold the parts with
both hands
●When the tape feeder is removed during production, remove in such a way that you
push the tape edge down.
●Do not put the tape feeder back in the middle of removal. Doing so may cause the
machine to stop due to blocking the light of the feeder opening sensor by the tape edge.
NOTE
2
Lift it up at the
stopper position
and remove
1
Pull up the lever
and pull out the
attachment
This procedure is performed when using the thin type tape feeder.
1
2
■Removing the dedicated attachment
How to hold the feeder
Hold the parts with
both hands
■Removing the thin type tape feeder
1
2