N7201A616E00_0317 - 第179页
NPM-W 2 EJM7DE-MB-02 O-00 1 2 1 2 Select whether to place or not on a head by head basis : place : Do not place 2 1 2 1 3 3 Select a target to cancel 2-5-6 -6 You can select multiple buttons and clear them all at once. S…
NPM-W2 EJM7DE-MB-02O-00
Specifying by the component (tray feeder)
1
A
E F
G
J
B
C
D
2
Select a placement point
2 3
F
H
I
2-5-6-5
A
B
C
F
G
H
I
J
3
Individu-
al
prepara-
tion
Placement specification 3
(conditional placement)
D
E
●You can select multiple points by
repeating steps and .
2
3
●Deselected by pressing the button
again.
Operating procedure
2-5-6
PalletPiece
Total number of trays registered in the
selected table.
SkipPiece
Total number of specified pallet to be
skipped.
ADR
Tray address No.
STK
Component ID number.
(When any stock component is available)
CompName
ANG
Component placement angle.
RTY
The frequency of retries.
Displays the previous or next table.
Tray
Scrolls and displays a long component
name.
1
NPM-W2 EJM7DE-MB-02O-00
1
2
1
2
Select whether to place or not
on a head by head basis
: place
: Do not place
2
1
2
1
3
3
Select a target to cancel
2-5-6-6
You can select multiple buttons and
clear them all at once.
Selecting the head
Deselecting the head
Preparation
NPM-W2 EJM7DE-MB-02O-00
2-5-7-1
Temp (℃)
Displays the preset temperature and
current temperature of the temperature
control unit.
Heater
Starts or stops the temperature control
of the temperature control unit.
Dispensor cnt
Warning (total)
The total number of dispensing count
warning is displayed.
Stop (sensor)
The number of dispensing count
sensor stop is displayed.
Stop (turn)
The number of dispensing count stop
is displayed.
The head moves over to the syringe
(nozzle) change position.
Eject time (s)
The time to dispense adhesive is entered
and displayed.
Eject speed
The rotation speed of the screw shaft in
adhesive dispensing is selected (only
engineer mode is selectable).
The number of dispensing count is reset.
The number of dispensing count at the
specified position is reset.
The adhesive is dispensed under the
conditions (dispensing time and speed)
specified against the selected nozzle.
Tape feed of the priming shot unit is
carried out.。
Individu-
al
prepara-
tion
Changing the Syringe
(dispensing head)
Operating procedure
2-5-7
This is used to change the syringe (nozzles) attached to the dispensing head unit.
●How to set syringe (→P.3-4)
C D E
B A
F F
H G I
J K
G
I
J
A
B
C
D
H
E
F
K
Nzl
The nozzle number is displayed.