N7201A616E00_0317 - 第410页

NPM-W 2 EJM7DE-MB-06O-0 0 6-1-16 -1 A A No zzle selection da ta edit (dispensing head) pos1/pos2 You can check and modify the nozzle contro l paramet er information used by each head . F I B E Control paramete rs of the …

100%1 / 714
NPM-W2 EJM7DE-MB-06O-00
Setting the drawing coordinates
From [Dispensing condition] screen (→ P.6-1-15-1)
Only when the drawing data exists
A
B
A
Pos Cnt
The point of draw coordinate in the
applicable list is displayed.
B
No
The number in sequence is displayed.
C
X[mm]
X dispensing coordinate is displayed.
D
Y[mm]
Y dispensing coordinate is displayed.
E
Pattern
Action pattern of the applicable
coordinate data is displayed.
For ‘Move’：
XY unit only move without
dispensing or drawing.
For ‘Straight’：
Draw straight line from the previous
coordinate.
For ‘Dispense’:
Perform dot dispensing.
C D E
6-1-15-6
Setting
change
NPM-W2 EJM7DE-MB-06O-00
6-1-16-1
A
A
Nozzle selection data
edit (dispensing head)
pos1/pos2
You can check and modify the nozzle control parameter information used by each head.
F
I B
E
Control parameters of the selected
nozzle position are displayed
DGH
J K C LM
B
The library screen of the nozzle shape
data is displayed.
C
The library screen of the adhesive data
is displayed.
D
Nozzle number
The nozzle shape code number of the
nozzle shape data used by the head is
displayed.
E
Adhesive Name
The adhesive name of the adhesive
data used by the head is displayed.
F
Remain warning count
You can check and edit the remaining
count warning.
G
Dispenser stop count
You can check and edit the dispensing
stop count.
H
DispenserStableT1 (s)
You can check and edit the dispensing
stabilizing timer (before dispensing).
I
DispenserStableT2 (s)
You can check and edit the dispensing
stabilizing timer (after dispensing).
Data
editing
Operating procedure
6-1-16
NPM-W2 EJM7DE-MB-06O-00
6-1-16-2
J
XY action speed
You can check and edit the XY speed in
production.
K
Spew speed
You can check and edit the dispensing
speed (rotation speed of the screw
shaft) in dispensing operation.
L
Pressure(MPa)
You can check and edit the air pressure
supplied to the syringe.
M
Temp offset (℃)
You can check and edit the material
temperature on a control temperature
unit. Offset value added to the
temperature set in the adhesive library
is set to the temperature control unit.
Setting
change