M1_ServiceManual_e.pdf - 第48页
Index Ａ Air filter, 3-2 Ｃ Camera, 3-6 Cleaning of disk drive, 4-3 Connecting loader wit h mounter, 1-6 Control boards, 4-4 Ｄ Daily checks, 2-2 Disk drive, 4-3 Ｅ Electrodes, 4-5 Environmenta l requirements, 1-2 Ｆ Feeder b…
4 Electrical Section
4-5
Electrodes on Feeder / Feeder Bank
When electrodes on the feeder bank and the tape feeder get dirty, clean them as follows:
Clean them very lightly to just get rid of the dust with dry cotton swab or nonwoven fabric. Check the pins
for deformation. If you find a bent pin, do not use the feeder as it is. It may result in a flaw on electrodes.
Do not use alcohol, water base detergents and organic solvent, such as thinner,
benzene and acetone.
Do not use sandpaper and tools with sharp blade or edge, such as a knife and a
screwdriver.
NOTE: If they get stubborn stains, try not to get rid of them forcedly. Please contact us.
Cotton swab
Pin Electrodes on feederElectrodes on feeder bank
Cotton swab
4 Electrical Section
4-6
Index
Ａ
Air filter, 3-2
Ｃ
Camera, 3-6
Cleaning of disk drive, 4-3
Connecting loader with mounter, 1-6
Control boards, 4-4
Ｄ
Daily checks, 2-2
Disk drive, 4-3
Ｅ
Electrodes, 4-5
Environmental requirements, 1-2
Ｆ
Feeder bank, 4-5
Floppy disk, 4-2
Ｈ
Handling floppy disk, 4-2
Head, 3-2
Ｉ
Installation, 1-2
Installing the mounter, 1-4
Ｌ
Lubricants, 3-14
Ｍ
Manual check, 2-3
Monthly check, 2-4
Ｎ
Nozzle, 3-3
Ｐ
Pre-process and post-process, 1-7
Production line, 1-3
Ｓ
Scan camera, 3-6
Specified lubricants, 3-14
Ｖ
visual check, 2-2
Ｗ
Write protect, 4-3