DFD6361-Maintenance - 第116页
B-44 Procedur es for re moving the fl ange (1. 8 kW s pindle) (C ontinued) St e p N o . Do This 8 Insert the bit into the center hole of the lock bolt. Loc k bolt Bi t 9 T urn the torqu e wrench counterclockwise. - The l…
B-43
Procedures for removing the flange (1.8 kW spindle)
Step No. Do This
1
Call up the BLADE REPLACEMENT screen [screen 4.1].
- The Y-axis moves to its origin position.
2
Make sure that the spindle is OFF.
3
Press the Disco's logo button located at the upper left of the
screen to lock up the touch panel.
4
Open the splash cover.
5
Remove the flange B lock nut, flange B and blade.
- For procedures to remove them;
See the section B-6 of Operation Manual, [Blade Maintenance].
6
Adjust the direction selector lever so that the wrench does not
turn free when you turn the torque wrench counterclockwise.
Direction selector lever
7
Have on hand the torque wrench set.
B-44
Procedures for removing the flange (1.8 kW spindle) (Continued)
Step No. Do This
8
Insert the bit into the center hole of the lock bolt.
Lock bolt
Bit
9
Turn the torque wrench counterclockwise.
- The lock bolt rotates counterclockwise and comes loose.
10
Remove the lock bolt and washer.
11
Screw the removing jig in the flange A until the jig reaches the
head of the spindle.
- In order to screw in the removing jig, turn it clockwise.
Turn the jig
clockwise.
12
When the removing jig contacts with the tip of the spindle, give
the jig another clockwise turn.
- The flange A comes off the spindle.
Continued in the next section.
B-45
2-3-2. Mounting the flange (1.8 kW spindle)
Safety precautions for mounting the flange (1.8 kW spindle)
WARNING
- In the flange mounting operation, you have to touch the spindle-axis
section and axis operating section directly by your hands. Unless
the spindle stops, your hands or fingers may be caught or cut off.
Before opening the splash cover, visually make sure from outside of
the cover that the spindle is completely stopped.
Ensure that no other person touches the machine during operation.
While you don't use the touch panel, press the Disco's logo button
located at the upper left of the screen in order to lock up and
deactivate the touch panel.
- If the spindle is rotated at a speed higher than the maximum
permissible speed for the blade outside diameter, blade breakage
or flange separation may occur and cause personal injury or
damage to the machine.
The spindle rotating speed varies depending on the outside
diameter of the installed blade. Be sure that the employed spindle
rotating speed is suitable for the outside diameter of the installed
blade.
Blade
diameter
[inch]
Maximum spindle
rotating speed
[min
-1
(rpm)]
Time to reach
maximum
speed [s]
Time needed for
complete stop [s]
2 60,000 30 15