DFD6361-Maintenance - 第285页
C-73 9. SECS/GEM Setup [User-Specified Specification] About SEC S/GEM set up The SECS/GEM setup makes it possible to perfor m communication between a machine and host computer, which en ables you to manage dat a held by …
C-72
8. Maker Data
About maker data
Maker Data refers to the maintenance screen used by DISCO maintenance
personnel.
The maker password is required to call up the maker data.
NOTICE
The maker data setup governs the standard data for the control of
each axis operation.
If its data is inappropriately specified, the machine may be damaged.
Even when you have a chance to know the maker password, do not
attempt to change the maker data unless a formal guidance or
instruction is given from DISCO.
C-73
9. SECS/GEM Setup
[User-Specified Specification]
About SECS/GEM setup
The SECS/GEM setup makes it possible to perform communication between a
machine and host computer, which enables you to manage data held by the
machine as well as collect the machine operation data.
For information about operation and specifications, technical documentation is
available only for the machines incorporating this function. See the technical
documentation.
D-1
D. TROUBLESHOOTING
Contents of this chapter
This chapter describes the causes, check points and remedies for the problems
that occur when turning ON the power or during machine operation and the
errors caused by the improper operation.
Section No. Title Contents
1 Remedies for Problems
Invoking No Error Code
Indication
- Problems at
Power ON -
- Check points for the problems
that occur at power-on
- Remedies for the problems that
occur at power-on
2 Remedies for Problems
Invoking Error Code
Indication
-Causesoftheerrorofwhich
error code is displayed when an
improper operation is performed
or in the event of failure during
machine operation
- Remedies for errors
Safety precautions to be observed during troubleshooting
In troubleshooting, observe the following safety precautions.
WARNING
- Troubleshooting must be carried out by qualified maintenance
personnel who have received maintenance training. While a
maintenance task is being performed, no one other than the
maintenance personnel must touch the machine.
- If you attempt to replace parts with the power left ON, you may
receive an electric shock or get your body caught by a drive section,
which may result in serious injury or death.
Before replacing any defective part, be sure to turn OFF the facility
power supply.
CAUTION
- While the machine is serviced, be sure that the power, air, N
2
or
water supply is not turned ON/OFF by irrelevant persons.
Special care must be taken particularly when the machine shares
the same facilities with other equipment.
- Use the digital tester for the measuring instrument. Do not use the
megohm tester.