DFD6361-Maintenance - 第338页

D-53 B0563 : Z 2-axi s at blade expos ure limit . Error c ode B0563 Message Z2- axis at blade expo sure li mit. W hat wa s detected The [work piece thick ness - Z2-axis blade height (cu t depth)] w as great er than the […

100%1 / 720
D-52
B0562 : Z1-axis at blade exposure limit.
Error code
B0562
Message
Z1-axis at blade exposure limit.
What was
detected
The value of [workpiece thickness - Z1-axis blade height (cut depth)] was
greater than the [current Z1-axis blade tip protrusion amount - (workpiece
thickness - Z1-axis blade height + clearance)].
During what
operation it
occurred
Before cutting.
State after
detection
No cutting operation can be started.
Phenomenon Probable causes Remedy Reference
What to do
Recovery
(1) Cancel the alarm.
(2) Replace the blade.
(If cutting needs to be continued, you can cut a single workpiece by
pressing the <START> button. However, the error recurs upon
completion of cutting to issue a warning.)
Maintenance level Maintenance personnel level Hazard level
Measuring equipment used Tools Replacement parts Protective gear
D-53
B0563 : Z2-axis at blade exposure limit.
Error code
B0563
Message
Z2-axis at blade exposure limit.
What was
detected
The [workpiece thickness - Z2-axis blade height (cut depth)] was greater
than the [current Z2-axis blade tip protrusion amount - (workpiece thickness
- Z2-axis blade height + clearance)].
During what
operation it
occurred
Before cutting.
State after
detection
No cutting operation can be started.
Phenomenon Probable causes Remedy Reference
What to do
Recovery
(1) Cancel the alarm.
(2) Replace the blade.
(If cutting needs to be continued, you can cut a single workpiece by
pressing the <START> button. However, the error recurs upon
completion of cutting to issue a warning.)
Maintenance level Maintenance personnel level Hazard level
Measuring equipment used Tools Replacement parts Protective gear
D-54
B0564 : Z1-axis at blade life limit.
Error code
B0564
Message
Z1-axis at blade life limit.
What was
detected
The length or counts of cut lines has reached the Z1-axis blade use limit
defined on the BLADE REPLACEMENT screen [screen 4.1].
During what
operation it
occurred
During the Z1-axis cutting.
State after
detection
The cutting operation is discontinued.
Phenomenon Probable causes Remedy Reference
What to do
Recovery
(1) Cancel the alarm.
(2) Replace the Z1-axis blade.
(If cutting needs to be continued, you can cut a single workpiece by
pressing the <START> button. However, the error recurs upon
completion of cutting to issue a warning.)
Maintenance level Maintenance personnel level Hazard level
Measuring equipment used Tools Replacement parts Protective gear