DFD6361-Maintenance - 第354页

D-69 B0595 : Z 2-axi s setup data error . Error c ode B0595 Message Z2- axis setup da ta erro r. W hat wa s detected An att empt was made to i nitiate cutting with the Z2-axis a lthoug h the Z2- axis se tup process w as …

100%1 / 720
D-68
B0594 : Z2-axis blade wear check error.
Error code
B0594
Message
Z2-axis blade wear check error.
What was
detected
The Z2-axis setup data for the blade wear check limit value was exceeded
by the difference between the current and previous setup values.
During what
operation it
occurred
After Z2-axis setup operation.
State after
detection
Setup data value registration does not take place.
Phenomenon Probable causes Remedy Reference
What to do
The error recurs
when setup is
attempted again.
Erroneous detection
occurs during setup
operation due to
water drops on the
setup position
section.
Increase the setup
data value for the
setup blow time
setting.
The non-contact
setup sensor is
soiled.
Clean the non-
contact setup
sensor.
The setup data value
for the Z2-axis blade
wear check limit
setting is too small.
Enter a limit setting
appropriate for the
Z2-axis blade wear
amount.
Recovery
(1) Cancel the alarm.
(2) Perform the customer-defined procedure for excessive blade wear.
(3) Perform the setup operation again.
Maintenance level Maintenance personnel level Hazard level
Measuring equipment used Tools Replacement parts Protective gear
D-69
B0595 : Z2-axis setup data error.
Error code
B0595
Message
Z2-axis setup data error.
What was
detected
An attempt was made to initiate cutting with the Z2-axis although the Z2-
axis setup process was not completed.
During what
operation it
occurred
At the beginning of Z2-axis cutting.
State after
detection
No cutting operation can be initiated using the Z2-axis.
Phenomenon Probable causes Remedy Reference
What to do
Recovery
(1) Cancel the alarm.
(2) Cancel the cutting operation and perform the Z2-axis setup process.
(3) After the Z2-axis setup process is normally ended, resume the cutting
operation.
Maintenance level Maintenance personnel level Hazard level
Measuring equipment used Tools Replacement parts Protective gear
D-70
B0660 : Blade detective error. (Z1 partial blade breakage)
Error code
B0660
Message
Blade detective error. (Z1 partial blade breakage)
What was
detected
Z1-axis blade breakage (blade fracture) was detected by the blade breakage
detector.
During what
operation it
occurred
At any time during cutting.
State after
detection
The Z-axis retreats to the upper end.
The X-axis returns to a location beneath the microscope. The Y- and
θ-axes decelerate and stop.
Phenomenon Probable causes Remedy Reference
What to do
The Z1-axis blade
is not broken but
the error occurs,
making it
impossible to
initiate cutting.
The Z1-axis blade
breakage detector
fiber is bent.
Replace the Z1-axis
fiber.
The wheel cover
section and fiber end
face are soiled.
Clean the fiber end
face.
Erroneous detection
occurs due to blade
wear.
Readjust the blade
breakage detector.
Recovery
(1) Cancel the alarm, and then the ERROR RECOVERY (BLADE
DETECTOR) screen is displayed.
(2) Perform the error recovery steps indicated on the screen.
Maintenance level Maintenance personnel level Hazard level
Measuring equipment used Tools Replacement parts Protective gear