DFD6361-Maintenance - 第398页

D-113 A0538 : θ adjustm ent retry over . Error c ode A0538 Message θ adjustm ent retry over . W hat wa s detected The error was disp layed wh en the θ alig nment was no t achieved al though realig nment was a ttempted th…

100%1 / 720
D-112
A0537 :Angle between channels error.
Error code
A0537
Message
Angle between channels error.
What was
detected
The θ-axis rotation between each channel exceeded the specified value in
the column < θ PERMISSION CH TO CH> on the ALIGNMENT DATA
screen [screen 5.3.4]
During what
operation it
occurred
During the operation of θ-axis rotation for automatic alignment.
State after
detection
Auto alignment operation is discontinued.
Phenomenon Probable causes Remedy Reference
What to do
The error occurs
frequently.
The value specified
in the column <θ
PERMISSION CH
TO CH> on the
ALIGNMENT
DATA screen [screen
5.3.4] is too small.
Correct the value
specified in the
column <θ
PERMISSION CH
TO CH> on the
ALIGNMENT
DATA screen
[screen 5.3.4].
Recovery
(1) Cancel the alarm, then the ERROR RECOVERY (ALIGNMENT)
screen is displayed.
(2) Perform the error recovery steps indicated on the screen.
Maintenance level Maintenance personnel level Hazard level
Measuring equipment used Tools Replacement parts Protective gear
D-113
A0538 : θ adjustment retry over.
Error code
A0538
Message
θ adjustment retry over.
What was
detected
The error was displayed when the θ alignment was not achieved although
realignment was attempted the number of times specified in the column
<RETRY COUNT> on theALIGNMENT DATA screen [screen 3.1.3].
During what
operation it
occurred
During auto alignment operation.
State after
detection
Auto alignment operation is temporarily halted.
Phenomenon Probable causes Remedy Reference
What to do
The error occurs
frequently.
The value specified
in the column <θ
ADJUST
PERMISSION> on
the ALIGNMENT
DATA screen [screen
3.1.3] is too small.
Correct the value
specified in the
column <θ
ADJUST
PERMISSION> on
the ALIGNMENT
DATA screen
[screen 3.1.3].
The value specified
in the column
[RETRY COUNT]
on the ALIGNMENT
DATA screen [screen
3.1.3] is too small.
Correct the value
specified in the
column [RETRY
COUNT] on the
ALIGNMENT
DATA screen
[screen 3.1.3].
Recovery
(1) Cancel the alarm, then the ERROR RECOVERY (ALIGNMENT)
screen is displayed.
(2) Perform the error recovery steps indicated on the screen.
Maintenance level Maintenance personnel level Hazard level
Measuring equipment used Tools Replacement parts Protective gear
D-114
A0539 : This work has been cut.
Error code
A0539
Message
This work has been cut.
What was
detected
During street adjustment in auto alignment, cutting lines were found on a
street.
During what
operation it
occurred
During street adjustment in auto alignment.
This detection function is effective only when "FIRST" or "ALWAYS" is
set for the item [CUT WORK CHECK WHEN ALI.] in the USER DEFINE
DATA screen [screen 7.4].
State after
detection
Auto alignment operation is discontinued.
Phenomenon Probable causes Remedy Reference
What to do
The straight-line
pattern on the street
line is misrecognized
as a cutting line.
The amount and
position of light during
street adjustment is not
appropriate.
Conduct
teaching again.
Recovery
(1) Cancel the alarm, then the ERROR RECOVERY (ALIGNMENT)
screen is displayed.
(2) Perform the error recovery steps indicated on the screen.
Maintenance level Maintenance personnel level Hazard level
Measuring equipment used Tools Replacement parts Protective gear