DFD6361-Maintenance - 第438页
E-2 Contents o f this cha pter (Conti nued) Section No. Titl e Contents Wheel mount conditioning Greasing the elevator ax is Greasing the frame cente ring axis 5 Maintenance to Be Pe rformed at 183-Day Interv als (Recomm…
E-1
E. MAINTENANCE
AND PERIODIC INSPECTION
Contents of this chapter
This chapter explains maintenance and inspection required for the machine by
the interval period.
Section
No.
Title Contents
Cleaning the Non-Contact setup sensor
Cleaning the blade breakage detector
sensor
Cleaning the spindle
1
Maintenance Whose
Interval Differs
Depending on the Machine Use
Conditions
Cleaning the touch panel
Checking stains on the safety labels
Checking the air spindle axis rotation
Checking the scratches and soiling on
the flange
Checking the soiling and damage on
the chuck table
Checking that the work being taken
over properly
Checking the air supply pressure
Checking the abnormal noise or
vibration produced by the spindle
during rotation
Checking the splash cover and arm
section cover status during spindle
rotation
Checking the splash cover and arm
section cover status during the spinner
table rotation
Checking Z EM sequence
Checking EMO switch activation
2
Maintenance and Inspection
to Be Done
Every Day
Checking the spinner high-pressure
pump pressure
Cleaning the cutting room
3
Maintenance to Be Performed at
7-Day Intervals
(Recommended)
Flange conditioning
4
Maintenance to Be Performed at
30-Day Intervals
(Recommended)
E-2
Contents of this chapter (Continued)
Section
No.
Title Contents
Wheel mount conditioning
Greasing the elevator axis
Greasing the frame centering axis
5
Maintenance to Be Performed at
183-Day Intervals
(Recommended)
Cleaning the spindle coolant water
path
Cleaning the vacuum ejector
Greasing the X-axis
Greasing the push-pull axis
Greasing the upper arm axis
Greasing the lower arm axis
Greasing the θ-axis sensor assembly
section
Greasing the Y (Y1 and Y2) -axis
6
Maintenance to Be Performed at
365-Day Intervals
(Recommended)
Greasing the Z (Z1 and Z2) -axis
E-3
1. Maintenance Whose Interval Differs
Depending on the Machine Use Conditions of
the Device
Summary of this section
This section describes maintenance whose service interval differs depending
on the machine usage conditions.
Section No. Title Contents
1-1 Cleaning the Non-Contact
Setup Sensor (Detection
Surface)
[Optional Accessory]
- Procedures for cleaning the non-
contact setup sensor
1-2 Cleaning the Blade
Breakage Detector Sensor
- Procedures for cleaning the
blade breakage detector sensor
1-3 Cleaning the spindle - Procedures for cleaning the
spindle
1-4 Cleaning the touch panel - Procedures for cleaning the
touch panel