DFD6361-Maintenance - 第481页
E-45 3-1. Cleanin g the Cutting Room Operation flow This section desc ribes the procedures for cleaning the c utting room, including cleaning of out er area an d inside of t he water case . The procedure for c leaning th…
E-44
3. Maintenance to Be Performed at 7-Day
(Recommended) Intervals
Summary of this section
This section describes the maintenance to be done at 7-day intervals.
Section No. Title Contents
3-1 Cleaning the Cutting
Room
- Procedures for cleaning the
cutting room
E-45
3-1. Cleaning the Cutting Room
Operation flow
This section describes the procedures for cleaning the cutting room, including
cleaning of outer area and inside of the water case.
The procedure for cleaning the cutting room consists of the following steps.
3-1-1 Cleaning the water case exterior
3-1-2 Cleaning the water case interior
Safety items for cleaning the cutting room
WARNING
If any touch panel control is inadvertently activated during
maintenance or inspection, unexpected machine operation may
cause death or serious injury.
While you don't use the touch panel, press the Disco's logo button
located at the upper left of the screen in order to lock up and
deactivate the touch panel.
NOTICE
Neither safety goggles, protective gloves, stepstools, flashlights nor
alcohol, all of which are necessary for maintenance work, are not
supplied with the machine. Use what are furnished in your factory or
what comply with your factory's standards.
E-46
Before cleaning
Have on hand the following items for cleaning the cutting room.
Soft cloth
Soft brush
Tweezers
Brush
Fine-grained oilstone
Alcohol
Neutral detergent
Waterproofing tape
Protective gloves
Safety goggles