DFD6361-Maintenance - 第482页
E-46 Before clea ning Have on hand the f ollowi ng ite ms for cleaning the cutting room. Soft cloth Soft brush Tweezers Brush Fine-g rained oilstone Alcohol Neutral det ergent Waterproofing tape Protective gloves Safet y…
E-45
3-1. Cleaning the Cutting Room
Operation flow
This section describes the procedures for cleaning the cutting room, including
cleaning of outer area and inside of the water case.
The procedure for cleaning the cutting room consists of the following steps.
3-1-1 Cleaning the water case exterior
3-1-2 Cleaning the water case interior
Safety items for cleaning the cutting room
WARNING
If any touch panel control is inadvertently activated during
maintenance or inspection, unexpected machine operation may
cause death or serious injury.
While you don't use the touch panel, press the Disco's logo button
located at the upper left of the screen in order to lock up and
deactivate the touch panel.
NOTICE
Neither safety goggles, protective gloves, stepstools, flashlights nor
alcohol, all of which are necessary for maintenance work, are not
supplied with the machine. Use what are furnished in your factory or
what comply with your factory's standards.
E-46
Before cleaning
Have on hand the following items for cleaning the cutting room.
Soft cloth
Soft brush
Tweezers
Brush
Fine-grained oilstone
Alcohol
Neutral detergent
Waterproofing tape
Protective gloves
Safety goggles
E-47
3-1-1. Cleaning the water case exterior
Procedures for cleaning the water case exterior
WARNING
- If your fingers or hands are placed under a rotating spindle, they
may be caught or cut off.
Before opening the splash cover, visually make sure the spindle
stops completely from the outside of the cover. Also, do not position
your fingers or hands beneath a rotating spindle.
- When you make air blow air for cleaning purpose, be sure to wear
safety goggles because broken workpiece, cutting particles or
drained water may get in your eyes.
CAUTION
If you clean the wheel cover with a blade mounted, the blade may be
broken during cleaning.
Before cleaning the wheel cover, remove the installed blade.
Step No. Do This
1
Press the <System Initial> button to effect system initialization.
2
From outside of the splash cover, visually make sure that the
spindle is stopped.
3
If any blade is attached to the spindle section, remove it.
- For the blade removal procedure;
See the section B-6, [Blade Maintenance] of the Operation
Manual.
4
Wear protective gloves and safety goggles.
5
Open the splash cover and arm section cover.