DFD6361-Maintenance - 第560页
E-124 6-7-4. Com pletion of greasi ng the Y-axis Procedur es for c ompleti on of gr easing the Y-ax is Step No. Do This (Continued from the previous section) 1 Turn ON the facility power source. 2 Open the circuit breake…
E-123
6-7-3. Greasing the rear of the Y-axis
Procedures for greasing the rear of the Y-axis
Step No. Do This
(Continued from the previous section)
1
Insert the grease gun into the grease nipples located at the top of
the Y1-axis base, and inject grease equally to five nipples.
Grease nipples of Y1-axis
2
Insert the grease gun into the grease nipples located at the top of
the Y2-axis base, and inject grease equally to five nipples.
Grease nipples of Y2-axis
3
With a lint-free cloth, wipe off any grease that protrudes from the
slider.
4
Reinstall the partition (left).
Continued in the next section.
E-124
6-7-4. Completion of greasing the Y-axis
Procedures for completion of greasing the Y-axis
Step No. Do This
(Continued from the previous section)
1
Turn ON the facility power source.
2
Open the circuit breaker lever lockout and then turn ON the
circuit breaker.
3
Insert the key into the main switch and then turn ON the main
switch.
4
Press the <System Initial> button to effect system initialization.
5
On the AXIS OPERATION screen [screen 7.2], shuttle Y1- and
Y2-axis between the front and rear end at least three times to
apply the grease uniformly to the entire axis.
E-125
6-8. Greasing the Z-axis
Operation flow
The procedure for greasing the Z-axis consists of the following steps.
6-8-1 Preparation of greasing the Z1-axis
6-8-2 Greasing the Z1-axis
6-8-3 Preparation of greasing the Z2-axis
6-8-4 Greasing the Z2-axis
6-8-5 Completion of greasing the Z-axis