SIPLACE D4-D4i 工程师手册_EN - 第195页

Measuring Equipment and Tools 5.1.1 Scope of Delivery Z End Stopper Star Gauge for C&P6/12 030 19865-xx Service Manual SIPLACE D4/D4i 195 5.9 5 . 9 Z E n d S t o p p e r S t a r G a u g e f o r C & P 6 / 1 2 0 3 …

100%1 / 248
Measuring Equipment and Tools
Compressed Air Testing Device [00311487-01] 5.1.1 Scope of Delivery
194 Service Manual SIPLACE D4/D4i
5.7
5.7 Compressed Air Testing Device [00311487-01]
Compressed Air Testing Device [00311487-01]
5.8
5.8 Location Tester
Location Tester
Use:
The compressed air tester is used to set the air blast at
the C&P6 and C&P12 placement heads in the SIPLACE
placement machines.
Use:
The location tester is used to check the feeder connec-
tions at the communication unit of the changeover table.
Measuring Equipment and Tools
5.1.1 Scope of Delivery Z End Stopper Star Gauge for C&P6/12 03019865-xx
Service Manual SIPLACE D4/D4i 195
5.9
5.9 Z End Stopper Star Gauge for C&P6/12 03019865-xx
Z End Stopper Star Gauge for C&P6/12 03019865-xx
5.10
5.10 Adjustment Aid for C&P DLM 00327005-xx
Adjustment Aid for C&P DLM 00327005-xx
Use:
The gauge is used to set the end stop position of the C&P
head Z axis.
Complete set [00327005-xx]
1. Gauge for star [00326164-xx]
2. Test probe 1.4 mm [00326160-xx]
3. Test probe 1.5 mm [00326161-xx]
4. Test probe 1.6 mm [00326162-xx]
5. Test probe 1.0 mm [00376656-xx]
6. Distance gauge [00325445-xx]
Measurement tools Application type
Gauge for star Setting the zero point correction for the star
Test probe 1.4 mm Setting the distance between the DP station incremental encoder and the glass
for the sleeve
Test probe 1.5 mm
Test probe 1.6 mm
Test probe 1.0 mm Setting the distance from the Z axis light barrier down to the sleeve shaft
Distance gauge Setting the distance of the valve plunger to the star
Measuring Equipment and Tools
Calibration Tool [03010565-xx] 5.1.1 Scope of Delivery
196 Service Manual SIPLACE D4/D4i
5.11
5.11 Calibration Tool [03010565-xx]
Calibration Tool [03010565-xx]
5.12
5.12 Calibration Nozzle for TwinHead [03008862-xx]
Calibration Nozzle for TwinHead [03008862-xx]
Use:
The calibration tool [03010565-xx] is used for calibration
of the DLM, CPP, P&P heads, TwinHead and PCB cam-
era.
Use:
The calibration nozzle is used to calibrate the D axis of
the TwinHead or P&P head.
NOTICE!
This nozzle is no longer needed from SW705.03.