SMN-Tape Feeder Manual(Eng Ver5).pdf - 第44页

Samsung SM-Series Pneumatic T ape Feeder Users' Manual 2-14 If the upper cover tape is used in the limitless dischar ge mode, exercise care so that the tape is not curled up. When upper cover tape is not dischar ged…

Operation of the Tape Feeder

2-13

If the vinyl box is filled with the upper cover tape (vinyl tape), the magnet moves up

automatically to open the vinyl box cover. Take out the upper cover tape and cut it

with the vinyl cutter at the back of the main frame and then close the vinyl box cover.

Figure 2-18. How to cut the upper cover tape (SM 24mm~88mm Tape Feeder)

Vinyl Cutte

Blade

Samsung SM-Series Pneumatic Tape Feeder Users' Manual

2-14

If the upper cover tape is used in the limitless discharge mode, exercise care so that the

tape is not curled up.

When upper cover tape is not discharged smoothly in the vinyl box since the upper cover

tape is highly adhesive, the vinyl is thin, or static electricity occurs, it is recommended to

use the upper cover in the limitless discharge mode. In addition, if the part dump rate

increases abnormally in the 24~88mm feeder, first check if it there is any problem with

applying the discharge method and contact our CS department.

그림

2-1. How to cut the upper cover tape (SM 24mm~88mm Tape Feeder)

Caution

Check if the upper cover tape flows down smoothly passing

between the covers at both sides of the part roller after it comes

out to the rear side of the vinyl box. Particularly, if the cover tape

is highly adhesive, it may be stuck to the inner side of the vinyl

box or curled up being stuck on the roll. Therefore, exercise care.

Upper Cover Tape

Operation of the Tape Feeder

2-15

2.1.6. Setting the Pickup Point

 8mm Tape Feeder

Move the component to the tape pickup point with a swing lever.

Figure 2-19. Setting the pickup point of the SM 8mm tape feeder

 12~16mm Tape Feeder

Figure 2-20. Setting the pickup point of the SM 12mm~16mm tape feeder

Manual Feeding