Autosite_Users_Manual - 第19页

Intr oduc tion AutoSite User Manual 1-5 Specifications Functional RAM 8 MB stan dard (on un its shipped a fter July 1997) Disk Format, Floppy Double-sided, Q uad-density 3.5-inch disk with 135 tracks per inch. 1 .44MB fo…

100%1 / 175
Introduction
1-4 AutoSite User Manual
The back panel features of the control unit are shown in Figure 1-3.
• ac Receptacle—Connects AutoSite to ac power.
• Power Switch—Applies ac power to AutoSite.
• Handler Port—Connects AutoSite to a PC.
• Auxiliary Port—Used for system diagnostics and field service.
• 50-pin Cable Port—A 50-pin cable attaches here, connecting the
AutoSite control unit to the pin driver head.
• 68-pin Cable Port—A 68-pin cable attaches here, connecting the
AutoSite control unit to the pin driver head.
The Pin Driver Head
The features of the pin driver head are shown in Figure 1-4.
1.
Pin Driver Head
—Contains the universal pin drivers that supply
power and ground to either 44 or 88 pins, depending on your system
configuration.
2.
Programming Site
—Programming modules, the DIP Base, and the
PLCC Base fit here, connecting the pin drivers in the pin driver head to
the socketed device.
Figure 1-3
Back Panel Features
Figure 1-4
Pin Driver Head Features
1379-2
AC RECEPTACLE
POWER SWITCH
HANDLER PORT
AUXILIARY PORT
50-PIN CABLE PORT
68-PIN CABLE PORT
J2 J1
1389-1
1
2
Introduction
AutoSite User Manual 1-5
Specifications
Functional
RAM
8 MB standard (on units shipped after July
1997)
Disk Format, Floppy
Double-sided, Quad-density 3.5-inch disk
with 135 tracks per inch. 1.44MB formatted
Disk Format, MSM
(optional hard drive)
Minimum of 80MB
Controller
Motorola 68000 16-bit microprocessor
Terminal Support
Interfaces with ANSI 3.64 compatible
terminals, IBM PCs and compatibles
running a terminal emulator program, and
many popular ASCII terminals
Communication
Standard
RS-232C
Data transfer rate
110 to 19.2 K baud (up to 115.2K baud
using TaskLink)
Power Requirements
Operating Voltages
90 to 264 Vac
Frequency Range
50–60 Hz
Power Consumption
150 VA maximum
Input Current
1.5A maximum
Physical and
Environmental
Dimensions
Control unit:
Pin driver head:
Weight
7.7 kg (17 lbs.)
Temperature
Operating: +5° to 40°C (+40° to 105°F)
Storage: +5° to 50°C (+40° to 122°F)
Transportation:
-40° to +55°C (-40° to +130°F)
Relative Humidity
Operating: to 80% noncondensing
Storage: to 90% noncondensing
Altitude
Operating: to 15,000 meters
17.15h x 33.65w x 28.5d cm
6.75h x 13.25w x 11.25d in.
8.9h x 27.3w cm
3.5h x 10.75w in.
Introduction
1-6 AutoSite User Manual
Safety
AutoSite is certified by UL, CSA, and TUV to comply with the following
safety standards:
Underwriters Laboratories
—UL 1950
Canadian Standards Association
—CSA C22.2 No. 231
Technischer
Überwachungsverein
—
TUV GS-Mark Certification
EN60950
Electrostatic
Discharge (ESD)
IEC 801-2 (± 8 kV)
Certificate of RFI/
EMI Compliance
The following paragraph applies to all units shipped after January 1996:
Data I/O certifies that the AutoSite complies with the Radio Frequency
Interference (RFI) and Electromagnetic Interference (EMI) requirements
of EN55022 Class A and EN50082-1 as called out in 89/336/EEC, the
EMC Directive for the European Community.
-EC conformity mark
WARNING: This equipment is a class A product. In a domestic
environment this product may cause radio interference in which case
the user may be required to take adequate measures.
Performance
Verification
AutoSite verifies internal voltages every time it is powered up and every
time a complete self-test is run. The voltage verification is performed by
software and is compared to a laser-trimmed voltage reference. Data I/O
recommends that you cycle power AND run a complete self-test cycle at
least every three months. Contact Data I/O for information on checking
the reference voltage and the master clock.
To ensure that your AutoSite continues to meet product performance
specifications, Data I/O recommends that your programmer be returned
to an authorized Data I/O Service Center every twelve months for a
complete performance evaluation.
R
R
PRODUCT
SERVICE
geprufte
Sicherheit