Autosite_Users_Manual - 第73页

Operation AutoSite User Manual 3-15 Removing a Base When removing a Base from AutoSite, be sure to apply even pres sure while moving the handles apart. If you exert uneven pressure on the handl es, you could d amage the …

100%1 / 175
Operation
3-14 AutoSite User Manual
6. As shown in Figure 3-9, set the Base onto the pin driver head, making
sure the guide pins on the pin driver head line up with the guide
holes in the Base.
7. Squeeze the Base and the clamp ring together, securing the Base to
the pin driver head. You do not need to use excessive force.
CAUTION: You can damage AutoSite by squeezing too hard.
With the Base installed in the pin driver head, you can perform the
following procedures:
• Update AutoSite to a new version of system software. See the
User
Notes and Update Instructions
that accompany the new software.
• Program PLCC devices one at a time. See the section titled “Inserting
PLCC Devices and Using MatchBooks” for more information.
Figure 3-9
Aligning the Base on the Pin
Driver Head
1381-1
PIN DRIVER
HEAD
DIP BASE
GUIDE PIN
(1 OF 4)
Operation
AutoSite User Manual 3-15
Removing a Base
When removing a Base from AutoSite, be sure to apply even pressure
while moving the handles apart. If you exert uneven pressure on the
handles, you could damage the clamp ring.
To remove a Base, follow the steps described below.
1. As shown in Figure 3-10, remove the Base by separating the handles
on the Base and the clamp ring with your thumbs and fingers.
2. Lift the Base up and out of the pin driver head. Store the Base in a safe
place.
CAUTION: Do not touch the pins that are exposed when you remove the
Base.
Once the Base is removed from AutoSite, we suggest you reinstall a
programming module in the pin driver head. For more information on
installing a programming module and reconnecting the pin driver head
to a handler, see the section titled “Changing a Programming Module”
earlier in this chapter.
Figure 3-10
Removing a Base
1380-2
DIP BASE
COMPRESSION HANDLE
Operation
3-16 AutoSite User Manual
Inserting a DIP
Device
To insert a DIP device into the DIP Base, follow the steps below:
1. Unlock the socket on the DIP Base by pulling up on the socket lever.
2. Insert the DIP device into the socket. Make sure the device is bottom
justified. If the device is not bottom justified, AutoSite will not be able
to read or program the device.
3. Lock the device into place by pressing the socket lever down.
Note: Insert DIP devices into AutoSite AFTER you have installed the DIP Base
in AutoSite.
Removing a DIP
Device
To remove a DIP device from the DIP Base, follow the steps below:
1. Make sure AutoSite has finished programming and testing the device
in the DIP Base.
2. Unlock the socket on the DIP Base by pulling up on the socket lever.
3. Remove the device by lifting it out of the socket. Set the device on an
antistatic surface or in antistatic foam.
Note: Remove DIP devices from the DIP Base before you remove the DIP Base
from AutoSite.
Figure 3-11
Inserting a DIP Device into the
DIP Base
0548-1
SOCKET LEVERS
UNLOCKED
PIN 1
SOCKET
LEVERS
LOCKED