Maintenance Reference(CP45FV) Eng.pdf - 第61页
Lubricant Method 4-5 4.2. Lubrication and Grease Application Caution It may shorten the average life span of a machine if grease not specified by our company is applied on the machine. Use the grease specified by our com…
Samsung Component Placer CP45FV Series Maintenance Guide
How to use a grease gun
Grease nipple-2(ea), Nipple tip-2(ea)
Reference
Grease Gun Set : Grease gun-1(ea), Using a grease gun for the conveyor
and LSO unit, Use the long type
nipple
Using a grease gun for the x-axis and
y-axis, Use the short type nipple tip.
1. Pull the cylinder lever back and fill
with grease.
3.Push the cylinder lever slightly and
remove the air in it using the handle.
2. Join the grease nipple and the body.
For the conveyor, LSO: long type nipple tip For the X-axis,Y-axis: short type nipple tip
4-4
Lubricant Method
4-5
4.2. Lubrication and Grease Application
Caution
It may shorten the average life span of a machine if grease
not specified by our company is applied on the machine.
Use the grease specified by our company.
4.2.1. Head
Inspection
Check the Ball Spline or the rail for discoloration or dust.
Noise may be generated if the lubricant has become too dry. Therefore, check the
state of lubrication.
LM Guide Rail
Ball Spline
Figure 4-1. Head Assembly Application
Solution
Remove any dust or foreign matter first and, if necessary, apply grease as thin as
possible on the ball spline or rail surface.
4.2.2. X-Y Frame
4.2.2.1. X-axis L/M Guide Rail
Inspection
Check the rail for discoloration or dust.
Check the lubricants on the rails. Insufficient lubricants on the rails could cause
unusual noise during operation of the machine.
Samsung Component Placer CP45FV Series Maintenance Guide
X-axis L/M Guide Rail & Bloc
k
Figure 4-2. X-axis L/M Guide Rail & Block
Solution
Clean any contamination or dust on the rail, and apply grease if necessary.
4.2.2.2. Y-axis L/M Guide Rail
Inspection
Check the rail for discoloration or dust.
Check the lubricants on the rails. Insufficient lubricants on the rails could cause
unusual noise during operation of the machine.
4-6