00197674-01-UM-E-Series-EN-05-2015 - 第204页

5 Working with the machine User manual SIPLACE E 5.4 Switching off the station From software version SC 708.0 05/ 2015 Edition 204 5.3.4 Action performed by machine start button The actio n performed by the st art button…

User manual SIPLACE E 5 Working with the machine

From software version SC 708.0 05/2015 Edition 5.3 Switching on the Machine

203

Fig. 5.3 - 1 "Production" view after loading the station software (example of SIPLACE E1 shown)

The status field (see section 5.6.1, page 207) shows the current status of the station and the action

to be performed.

 Press the start button on the HMI when you see the request "Press the Start button to begin

production".

A reference run will be performed. After completion of this reference run, the station is ready

for operation.

The icon will be shown in the working area of the user interface (enabled).

5 Working with the machine User manual SIPLACE E

5.4 Switching off the station From software version SC 708.0 05/2015 Edition

204

5.3.4 Action performed by machine start button

The action performed by the start button can be set.



Open the Check sensors and functions view (see section 5.6.3, page 208).

The following settings are possible:

Start production automatically 5

Standard setting.

Pressing the start button automatically begins the production process.

Do not change production status 5

This is used, for example, to calibrate and test the machine

Pressing the start button simply closes the electricity circuit; production is not started immediately.

5.4 Switching off the station

To switch off the station, proceed as follows:

 End all placement procedures, so that there are no more boards in the machine.

 Check whether the Z axes of all placement heads are in their uppermost end positions.

 Check whether there are still components on the placement heads and remove these.

 Close the station computer software in the view

Set settings and options --> Check and set machine settings --> Shut down

machine...

 Once the computer has been shut down, switch off the station at the main switch.

CAUTION

Machine functions can be directly started via the GUI, irrespective of the start button set

ting. If the electrical circuit has already been closed, you do not need to confirm with the

start button again.

User manual SIPLACE E 5 Working with the machine

From software version SC 708.0 05/2015 Edition 5.5 Opening and closing the protective covers

205

5.5 Opening and closing the protective covers

The protective covers are electrically and mechanically locked and cannot be opened during op

eration.

Opening the protective covers 5

 Press the stop button to open the protective cover.

– A message is issued at the station software stating that the protective covers can be

opened.

– The protective covers are mechanically released and can be opened.

Closing the protective covers 5

 Close the protective covers.

 Press the start button.

– The protective covers are mechanically locked and can no longer be opened.