Transport Rails Module.pdf - 第26页

TRANSPORT RAILS MODULE ADJUSTMENTS AND SETTINGS 16.26 Technical Reference Manu al Chapter Issue 4 Jan 10 26. Select Exit . 27. Use Next or Previous to highlig ht Rising T able . 28. Select Select Module . 29. Use Next or…

100%1 / 44
TRANSPORT RAILS MODULE
ADJUSTMENTS AND SETTINGS
Chapter Issue 4 Jan 10 Technical Reference Manual 16.25
Rail to Table Height
WARNING
BOARD CLAMPS. EXTREME CARE MUST BE EXERCISED WHEN WORKING IN
THE TOOLING AREA OF THE MACHINE TO AVOID INJURY. THE FOILS ON THE
FRONT AND REAR BOARD CLAMPS ARE VERY SHARP.
The rail to table height ensures that the board is supported correctly and evenly
during the print process.
NOTE
This setting is factory set and shouldn’t normally need to be adjusted.
Use the following procedure to check and adjust the rail to table height:
1. Select Open Cover Commands.
2. Select Carriage To Rear.
3. Select Unload Screen.
4. Open the front printhead cover.
5. Remove the screen from the machine.
6. Remove any tooling close to the board clamps.
7. Close the front printhead cover.
8. Press the System button.
9. Select Back.
10. Select Maintenance.
11. Select Diagnostics.
12. Use Next or Previous to highlight Camera Axes.
13. Select Select Module.
14. Ensure Home Camera X Axis is highlighted.
15. Select Run Diagnost.
16. Use Next or Previous to highlight Home Camera Y Axis.
17. Select Run Diagnost.
18. Select Exit.
19. Use Next or Previous to highlight Rail System.
20. Select Select Module.
21. Select Adjust, the following window opens:
22. Set the board width to 250mm.
23. Select Exit.
24. Use Next or Previous to highlight Drive Rail to Board Width.
25. Select Run Diagnost.
Rail System Test Parameters
BOARD WIDTH
CYCLE COUNT
250.0
50
mm
Cycles
TRANSPORT RAILS MODULE
ADJUSTMENTS AND SETTINGS
16.26 Technical Reference Manual Chapter Issue 4 Jan 10
26. Select Exit.
27. Use Next or Previous to highlight Rising Table.
28. Select Select Module.
29. Use Next or Previous to highlight Raise Table to Vision Height.
30. Select Run Diagnost.
31. Select Exit.
32. Use Next or Previous to highlight Rail System.
33. Select Select Module. The board clamps are released.
34. Use Next or Previous to highlight Toggle Board Clamp.
35. Open the front printhead cover.
TRANSPORT RAILS MODULE
ADJUSTMENTS AND SETTINGS
Chapter Issue 4 Jan 10 Technical Reference Manual 16.27
36. There are two Rail to Table Height Setting Kits:
• 193177 for use with transport rails with round belts (red height gauges)
• 193178 for use with transport rails with flat belts (blue height gauges)
37. Check which type of transport belts are on the machine and select the
appropriate kit.
38. If the machine has transport rails with flat belts, go to Step 47.
39. Remove the transport belt from the front rail.
40. Remove two steel dowels from the kit.
41. Place a steel dowel on the front belt support plate aligning with the edge of
the board clamp.
42. Place another steel dowel on the belt support plate aligning with the other
end of the board clamp.
43. Remove the two height gauges from the kit.