4OM-996-007 - 第136页

1.4 Maintenance Method (2) When the [Start Oil Supply] button is pressed in the "Oil Supply" tab sheet, the following sheet appears. Fig. 4A85-2 (3) Press the [ALL] button (entitled "ZERO"). In two se…

1.4 Maintenance Method

1.4.9 Lubrication of Linear Guide in Feeder Carriage Section

Grease should be applied every 6 months after the initial month.

••

• Preparation for Lubrication

(1) Turn off the power supply to the machine and wipe off old grease

on the rail of the linear guide with a rag.

(2) Prepare the FL- and P-type attachments.

The combination of the U- and P-type attachment can also be

used for lubrication from the front side of the machine.

Fig. 4A85

••

• Lubrication Procedure

The linear guide in the feeder carriage section must

be lubricated with the [POWER ON] button on the

operation panel being pressed ("ON" condition).

It is dangerous. Be sure to lubricate alone (without

any other attended personnel).

(1) Press the [UNIT ADJ.] button on the submenu bar that appears after

the [MAINT.] button is selected.

When the [Oil Supply] tab is pressed in the "Fdr Crg" tab sheet, the

following tab sheet appears.

Fig. 4A85-1 "Oil Supply" Tab Sheet

CAUTION

FL Type

P Type

U Type

0509-004 1-69 AIM01ETRP

Note

1.4 Maintenance Method

(2) When the [Start Oil Supply] button is pressed in the "Oil Supply" tab

sheet, the following sheet appears.

Fig. 4A85-2

(3) Press the [ALL] button (entitled "ZERO"). In two seconds, press the

[ENABLE] button on the operation panel. All devices are zeroed.

(4) Press all the buttons (entitled "FEEDER READY").

(5) Press the [ON] button entitled "MOVE". In 2 seconds, press the [EN-

ABLE] button on the operation panel.

All axis automatic tuning takes place and the following sheet ap-

pears. (The feeder carriage moves slightly.)

0305-001 1-70

AIM01ETRP

1.4 Maintenance Method

(6) Press the [ON] button entitled "MOVE". In 2 seconds, press the [EN-

ABLE] button on the operation panel.

The feeder carriage moves to the grease supply position and the

following sheet appears.

Fig. 4A85-3

(7) Press the [EMERGENCY STOP] switch and open all the doors.

Apply grease to the nipples on the slide blocks of linear guides.

After that, close all the doors.

(8) Unlock the [EMERGENCY STOP] switch and press the [RESET]

button. Press the [POWER ON] button to power the machine.

Press the [ALL] button (entitled "ZERO"). In 2 seconds, press the

[ENABLE] button on the operation panel.

0305-001 1-71

AIM01ETRP