00195377-0102 - 第28页

Retrofit instructions: Flexible dual conveyo r, SIPLACE D4 04/2007 Edition 28 : Insert the new hexagonal shaf ts into the conveyor . The shoulder always point s to the motor side. Use the holes in the opposite conveyor r…

100%1 / 34
Retrofit instructions: Flexible dual conveyor, SIPLACE D4
04/2007 Edition
27
: Use a power drill / cordless screwdriver and a metal drill bit (Ø 4.0 mm) to drill two holes
through the gauge and into the extension kit.
2
: Remove the drilling swarf on and around the drill holes using a vacuum cleaner, for example.
: Debur the drill holes using a Rose bit.
2
: Screw on all the four separating layers.
2
Drill holes
Separating layer:
the long side (3 screws) must always point downwards,
the vertical side (2 screws) must always be inside.
Retrofit instructions: Flexible dual conveyor, SIPLACE D4
04/2007 Edition
28
: Insert the new hexagonal shafts into the conveyor.
The shoulder always points to the motor side.
Use the holes in the opposite conveyor rails to insert the hexagonal shafts for the center belt.
2
: Push the conveyor rails inwards.
2
: Fasten the fixing blocks to the hexagonal shafts.
2
2
Hexagonal shaft with shoulder
Retrofit instructions: Flexible dual conveyor, SIPLACE D4
04/2007 Edition
29
: Screw the fixing blocks with the hexagonal shafts to the sides in the conveyor area and to the
separating layers in the extension kits.
2
Fixing blocks