4OM-1505-004_w.pdf - 第76页
4OM-1505 1-25 3. Maintenance Spots : Chap.1 PEC Recognition Y -Axis Linear Guide (Front Left Side) Every 6 Months Lubrication Use the H-type attachment. PEC Recognition Y -Axis Linear Guide (Front Right Side) Every 6 Mon…
4OM-1505
1-24
3. Maintenance Spots : Chap.1
3.2.4 PEC Recognition Section
PCB Stopper
PCB Warpage Top Holder
(Plunger End Section)
In the case that dust is attached
to the pressing surface, remove it.
Every Week Cleaning
Clean the stopper with an oiled rag.
Every Week Cleaning
Do not leave any waste
threads after cleaning.
Camera (Lens)
PEC Recognition Lighting Glass
Surface
Remove dirt and dust with an ari
blow brush for camera.
Every Month Cleaning
PEC Recognition X-Axis
Linear Guide
Every Month Cleaning
PEC Recognition X-Axis
Linear Guide
Apply grease with a brush or a
spatula.
Every 6 Months Lubrication
Clean the stopper with an oiled rag.
Do not leave any waste
threads after cleaning.
Note
Note
F4A13
1002-002
4OM-1505
1-25
3. Maintenance Spots : Chap.1
PEC Recognition Y-Axis
Linear Guide (Front Left Side)
Every 6 Months Lubrication
Use the H-type attachment.
PEC Recognition Y-Axis
Linear Guide (Front Right Side)
Every 6 Months Lubrication
Use the H-type attachment.
Inject new grease from the grease
nipple with a brush or a grease gun.
Inject new grease from the grease
nipple with a brush or a grease gun.
PEC Recognition
Y-Axis Linear Guide
Every Month Cleaning
Do not leave any waste
threads after cleaning.
PEC Recognition
X-Axis Ball Screw
Apply grease with a brush or a spatula.
If a large amount of grease is
applied, it may be dispersed
over a PCB and the stencil.
After applying grease, brush
the surface or scrape with a
spatula until a small amount
of grease remains on the
surface of the ball screw.
Every 6 Months Lubrication
Note
Clean the stopper with an oiled rag.
Note
Note
Note
F4A14
0906-001
4OM-1505
1-26
3. Maintenance Spots : Chap.1
PEC Recognition X-Axis
Ball Screw
Apply grease with a brush or a
spatula.
If a large amount of grease is
applied, it may be dispersed
over a PCB and the stencil.
After applying grease,
brush the surface or scrape
with a spatula until a small
amount of grease remains
on the surface of the ball
screw.
Every 6 Months Lubrication
PEC Recognition Y-Axis
Linear Guide (Rear Side)
PEC Recognition Y-Axis
Linear Guide
Clean the stopper with an oiled rag.
Every Month Cleaning
Do not leave any waste
threads after cleaning.
Every 5 years Lubrication
Use the H-type attachment.
Inject new grease from the grease
nipple with a brush or a grease gun.
Rear Side
Rear Left Side
Note
Note
Note
F4A15
0906-001