ts9800-user-guide-7511-0360_A - 第38页
38 6. Touch ‘ Accept ’ icon to exit 7. To uch ‘ F all Tim e ’ ic on to enter the setup screen 8. Touch the up and down arrows to set the desired fall time in µs. Caution: The minimum fall time is 80 µs and the ma ximum f…
37
3. If the master password is correct the next menu will pop up
4. Touch ‘Accept’ icon to accept and exit
5. Once the master password is comfirmed the password will reset to
0000.
9.5.5 Setup Dispensing Parameters
All essential dispensing parameters can be accessed from the home
screen.
1. Touch ‘Rise Time’ icon to enter the setup screen
2. Touch the up and down arrows to set the desired rise time in µs.
Caution: The minimum rise time is 80 µs and the maximum rise
time is 1999 µs.
3. Touch ‘Accept’ icon to exit
4. Touch ‘Open Time’ icon to enter the setup screen
5. Touch the up and down arrows to set the desired open time in µs.
Caution: The minimum and maximum open time is 1 to 9999 µs.
38
6. Touch ‘Accept’ icon to exit
7. Touch ‘Fall Time’ icon to enter the setup screen
8. Touch the up and down arrows to set the desired fall time in µs.
Caution: The minimum fall time is 80 µs and the maximum fall
time is 1999 µs.
9. Touch the ‘Accept’ icon to exit
10. Touch the ‘Delay Time’ icon to enter the setup screen
11. Touch the up and down arrows to set the desired delay time in
µs.
12. Touch the ‘Accept’ icon to exit
13. Touch the ‘Pecentage Lift’ icon to enter the setup screen
14. Touch the up and down arrows to enter the desired percentage
lift for the tappet to open/lift.
39
15. Touch the ‘Accept’ icon to exit
16. Touch the ‘Pulse’ icon to enter the setup screen
17. Touch the up and down arrows to set the desired number
strokes per dispensing cycle.
18. Touch the ‘Accept’ icon to save and exit
19. Enter all desired dispensing parameters, then touch ‘Save’ icon
Note: The system will automatically calculate and display the operating
frequency based on the entered dispensing parameters.
9.5.6 Calling up Dispensing Parameters
The controller has 50 memory cells store all dispensing parameters.
1. Touch the forward or backward arrow to select
the desired memory cell or touch the value to type in a specific
location.
2. Touch the ‘Accept’ icon to exit
9.5.7 Reset Cycle Counter
The cycle counter records the number of dispense cycle being activated.
Up to 999,999,999 cycles can be recorded for each of the program saved
in memory. To reset the counter for the current program, follow the
steps below: