00193915-0202_AI_PSA_ KitZuführmodule8S_DE EN - 第30页
2 Assembly instructions PSA Kit for 8/12/16mm S feeder modules PSA Kit for 8/12/16mm S feeder modules 12/2006 Edition 30 2.1.2 Converting the feeder : Fit the conc ave roller wit h the collar screw on th e new cover stri…
PSA Kit for 8/12/16mm S feeder modules 2 Assembly instructions PSA Kit for 8/12/16mm S feeder modules
12/2006 Edition
29
: Before lifting the right-hand feeder module, remove the two foam cubes in the rear cut-out (they
can be seen after the cable cover (2) is removed).
: Hexagon socket head screw M 2.5 from the underside of the base element (3).
: Hexagon socket head screw M 2.5 in the cut-out in the right-hand feeder module (2).
: Raise the right-hand feeder module vertically until it comes away from the locating pins in the
base element (5). Do not pull the cables, otherwise the plug-in connectors on the board may
come away.
: Carefully tilt the removed feeder module with the side surface facing outwards so that it lies
lengthwise beside the base element.
CAUTION
Do not detach the drawer unit in the base element. The cable connections from the feeder module
to this drawer unit are long enough if you carefully tilt the feeder module outwards during removal
and place it beside the base element.
Do not pull the cables as you do this. 2
NOTE
If you have opened the right-hand side panel, it is a good idea to grease the stop, the pinion and
the outer circumference of the worm (1-3) sparingly with Isoflex Topas L30 (item no. 00303140-
01). 2
2
2
2
2
2
2
2
2
2
2
2
2 Assembly instructions PSA Kit for 8/12/16mm S feeder modules PSA Kit for 8/12/16mm S feeder modules
12/2006 Edition
30
2.1.2 Converting the feeder
: Fit the concave roller with the collar screw on the new cover strip rocker from the retrofit kit.
2
2
: Remove the cover strip rocker and the board from the feeder module (1 slotted-head screw).
2
The spring can easily drop out during removal. 2
2
2
PSA Kit for 8/12/16mm S feeder modules 2 Assembly instructions PSA Kit for 8/12/16mm S feeder modules
12/2006 Edition
31
: You will not need the old cover strip rocker or roller again.
: Fit the new cover strip rocker (with concave roller) in the board.
2
Use the hinged roller, rather than the metal roller. 2
2
2
: Insert the board and screw it firmly (1 slotted-head screw).
: Insert the spring.
: Insert the cover strip as shown:
2
: Fold the board back in again fully.
This roller must be removed.
This roller must be fitted.
With the new cover strip rocker