NPM Calibration Manual-En - 第9页

NPM Maint en anc e E di ti on 9.3 Pl ane Com pensati on XY Page 9-8 EJM9BE-M B-09M-21 6 Press + [OK]. • T he head mov es to the r etracti on positi on. 7 Turn OFF the se rvo switch. 8 Open the s afety cover. 9 Set the p …

100%1 / 99
NPM
Maintenance Edition
9.3 Plane Compensation XY
EJM9BE-MB-09M-21 Page 9-7
9.3 Plane Compensation XY
This procedure is common to 12-nozzle, 8-nozzle, and 2-nozzle heads.
Since the plane-compensation jig is loaded from the upstream process and unloaded to the downstream
process, adjust the width of the upstream and downstream transfer conveyors to that of the
plane-compensation jig.
Remove all support-pins before performing calibration.
For the dual conveyor type, put the conveyor into single lane mode.
( Steps 1 through 7 in “10.5 Single Lane Mode Selection on the Dual Conveyor”.
It is not necessary to attach the board support blocks (for single lane mode).)
1
Set the plane-compensation jig to the
upstream process.
2
Press .
3
Press [PlaneCorrXY].
∗
Check that no PCBs remain in the machine.
4
Press + [Jig carry in].
•
An error message is displayed if there are
remaining PCBs in the machine.
∗
After removing the remaining PCBs, press
[Jig carry in] again.
5
Press + [Run].
•
The conveyor width is adjusted automatically.
Load the plane-compensation jig.
UnitCalibAxisSurface-02E00
5
UnitCalibAxisSurface-01E00
2
3
4
NPM
Maintenance Edition
9.3 Plane Compensation XY
Page 9-8 EJM9BE-MB-09M-21
6
Press + [OK].
•
The head moves to the retraction position.
7
Turn OFF the servo switch.
8
Open the safety cover.
9
Set the plane-compensation jig with
its right end fit to the reference mark
on the upper surface of the front rail.
∗
(Common to both the left-to-right and
right-to-left flows.)
10
Close the safety cover.
11
Turn ON the servo switch.
UnitCalibAxisSurface-03E00
6
Reference mark
NPM
Maintenance Edition
9.3 Plane Compensation XY
EJM9BE-MB-09M-21 Page 9-9
12
Press [OK].
13
Press + [PlaneCorrXY].
•
The calibration on the front side is carried out,
followed by that on the rear side.
14
Check that it is successfully complete.
UnitCalibAxisSurface-04E00
12
UnitCalibAxisSurface-05E00
13
UnitCalibAxisSurface-06E00
14