NPM Calibration Manual-En - 第97页

NPM Maint en anc e E di ti on 9.14 Accu racy Ve rificat ion Page 9-96 EJM9BE-M B-09M-21 ④ Check ing an d Refl ecti on of Pl aceme nt Resul ts 1 After p lacement is com pl ete, press . 2 Press [Yes]. Autom ati c operati o…

100%1 / 99
NPM
Maintenance Edition
9.14 Accuracy Verification
EJM9BE-MB-09M-21 Page 9-95
7
Place the components.
The components are placed by automatic
operation.
After all the components are placed, the head
camera starts measuring the placement
positions.
NPM
Maintenance Edition
9.14 Accuracy Verification
Page 9-96 EJM9BE-MB-09M-21
④
Checking and Reflection of Placement Results
1
After placement is complete, press
.
2
Press [Yes].
Automatic operation is complete.
3
Press .
4
Press .
5
Press [Target].
•
Chip component 0.040 mm
•
Irregular-shaped component
0.030 mm
6
Select the table.
displays the individual
and the general accuracy on the front and the
rear.
7
Display the placement accuracy.
If the measurement result CpK is lower than
the prescribed value, reflect the each-angle
offset.
ProductionProc-02E00
2
ProdConditionVarifyCPK-01E01
3
4
5
ProdConditionVarifyCPK-01E01
8
6
7
NPM
Maintenance Edition
9.14 Accuracy Verification
EJM9BE-MB-09M-21 Page 9-97
8
To reflect the placement offset, press
[Each angle offset].
Pressing [Each angle offset] displays the
screen shown left.
9
Select the desired nozzle.
10
The offset of each nozzle is
displayed.
11
Select the desired table.
12
Select the placed components.
The display depends on the placed component
type.
13
To reflect the verification data, press
[Data Reflect].
Pressing [Data Reflect] displays the screen
shown left.
14
Press [Yes].
Pressing [Yes] reflects the data and updates
the parameters.
•
All the heads and nozzles concerned with
placement are updated.
•
Regardless of the selected table, the offsets
of all the heads and nozzles are updated.
This concludes the placement offset reflecting
procedure.
You can check the placement accuracy result
by placing them again. In that case, perform
the procedure “3 Checking of Placement
Results.”
UnitParamHeadEachAngle-01E05
11
9
10
13
12
14