1OM-1505-004_w - 第119页
1OM-1505 3-14 2. Squeegee Replacement and Solder Paste Replenishment : Chap.3 2. Squeegee Replacement and Solder Paste Replenishment The squeegees can be replaced or solder paste can be replenished during the automatic o…
1OM-1505
1. Automatic Operation : Chap.3
3-13
1.4.2 Logout
When the operation window is to be closed, When the operation window is to be
closed, press the [Return] button on the common menu bar or the maintenance
menu bar.
The operation window closes and the "Top" window reappears.
F1C14
Note
(a) Whenever an edit window such as the "Pattern Program Data" window is
active, follow the speci ed steps to close the window before the [RETUTN]
button is pressed.
(b) When the power to the machine is to be shutdown after the logout
operation, press the [SHUTDOWN] button.
Refer to "4.2 Power OFF" in "Chapter 2" for details.
Reference
Refer to "4.2 Power OFF Operation" in "Chapter 2" for details.
1002-002
1OM-1505
3-14
2. Squeegee Replacement and Solder Paste Replenishment : Chap.3
2. Squeegee Replacement and Solder Paste
Replenishment
The squeegees can be replaced or solder paste can be replenished during the
automatic operation with the machine in the "STOP" or the "PAUSE" mode.
2.1 When "Squeegee Limit" is reached:
When the number of printing operations reaches the rate (percentage) specied
in the "Sqg. Limit" group box in the "Squeegee Change" tab sheet during the
automatic operation, an error alarm is issued and the machine stops running.
In this case, follow the steps below to replace the squeegees and restart the
automatic operation.
Procedure
(1) When the number of printing operations reaches the rate (percentage)
specied for the "Sqg. Limit", the error window appears.
(2) Press the [RESET] button to cancel the error alarm.
(3) Press the [Squeegee Change] tab.
(The following tab sheet will be displayed.)
F1C15
(4) Press the [Squeegee Chg. Pos. Move] button and press the [START] button
on the operation panel.
The squeegees are moved to the change position.
(5) Press the cover lock switch.
(6) Open the transparent cover on the machine front.
1002-003
Graphic
Development
1OM-1505
2. Squeegee Replacement and Solder Paste Replenishment : Chap.3
3-15
(7) Push down the mechanical valve switch (used to clamp the squeegee) to the
left side (unclamping) and pull down the squeegee from the squeegee holder
to detach.
Squeegee
Mechanical Valve Switch
(to clamp the squeegee)
F1C16
(8) Push down the mechanical valve switch to the right side to clamp the
squeegee.
Note
(a) Hold the squeegee securely and attach it. If the squeegee falls down on the
stencil, the stencil may be damaged.
It is recommended that a protective plate should be prepared by the user
and placed it on the stencil.
(b) The squeegee should be clamped from the rear side of the holder and then
from the front side.
1002-002