1OM-1505-004_w - 第127页

1OM-1505 5. Running-In Operation : Chap.3 3-22 1002-002 5. Running-In Operation After the machine has been stopped for a long period of time, perform a running- in operation for approx. 30 minutes to smoothly start up th…

1OM-1505

4. Automatic Operation Stop, Interruption and Re-Start : Chap.3

3-211002-003

4.2 Interruption of Automatic Operation

To stop the machine immediately in an emergency, press the [EMERGENCY

STOP] switch.

[EMERGENCY STOP] Switch

F1C24

An alarm is issued and the [POWER ON] button illuminates in red.

4.3 Automatic Operation Re-Start

When the [START] button on the operation panel is pressed, the automatic

operation is re-started.

Note

Once the zeroing operation has been performed, the automatic operation can be

re-started even when each axis is not zeroed.

1OM-1505

5. Running-In Operation : Chap.3

3-221002-002

5. Running-In Operation

After the machine has been stopped for a long period of time, perform a running-

in operation for approx. 30 minutes to smoothly start up the machine.

Procedure

(1) Select an appropriated pattern program in the "PRGM. CHANGE" window

in the "Setup" menu and perform the processing until the completion of the

conveyor width setup operation.

(2) Press the "TEST Opn. Mode" tab.

(The following tab sheet will be displayed.)

[1]

[2]

[3]

Select one for "RUN MODE"

Select "ON" or "OFF"

for each operation item

Select "ON" or "OFF"

for each operation item

Save the setting

F1C25

(4) Press the [TEST] button for the "RUN MODE".

(5) Select "ON" or "OFF" for each item in the "TEST RUN SPECIFY" pane and

press the [Data Save] button.

(The specied test pattern will be set for the running-in operation.)

(6) Press the [START] button on the operation panel.

(The running-in operation will be started.)

Note

To stop the running-in operation, press the [STOP] button on the operation

panel.

Graphic

Development

1OM-1505

0906-001 4-A

Chapter 4

Program Change Operation

This chapter describes how to perform a program change operation.

1. Outline of Program Change Operation

2. Preparation for Program Change Operation

3. Program Change Operation

4. Test Print and Automatic Operation