DECAN_S2_Admin(Eng_Ver4.5).pdf - 第185页
7-20 Advanced Chip Shooter DECAN S2 Admi nistra t or’s Guide <Enable Pocket T each> check box If this check box is selected, the Pocke t T each function of the feeding d evice that feeds the corresponding part is…
7-19
Part Registration
That is, the speed is controlled in 2 steps for the Z axis. For example, if cracks
occur frequently in the part. The overall speed of the Z axis may be reduced.
However, in this case, overall efficiency decreases.
At this time, the work can be done efficiently using this function.
Not Use: Set this function so that it is not used.
Pick: Set this function so that it is used only for pickup.
Mount: Set this function so that it is used only for placement.
Pick&Mount: Set this function so that it is used only for pickup and
placement.
Caution In case of shock sensitive components like CSP or μBGA,
the z-axis related speed parameters must be set according
to the component manufacturer’s specification or standards.
And use the nozzle suitable to component manufacturer’s
specification or standards.
If necessary, please contact our Business Department or
the local agent for the nozzle suitable to component
manufacturer’s specification or standards.
7-20
Advanced Chip Shooter DECAN S2 Administrator’s Guide
<Enable Pocket Teach> check box
If this check box is selected, the Pocket Teach function of the feeding device that
feeds the corresponding part is automatically set up in the 'Feeders' dialog box.
In order to allow the Pocket Teach to be actually applied, the Pocket Teach option
of the Preference submenu of the System Setup menu must be set up.
Memo For parts fed by an 8mm tape feeder, it is recommended that this
function be applied.
Basically, the black splicing tape must be used.
<Pick Up Data> button
Sets the offset of the pickup point coordinate when picking up a specific part. For
some specific parts, the pickup point set by default may differ from the actual
pickup point.
(Example: It is not possible to pick the part at the center)
At this time, after teaching the actual pickup point for the corresponding part, save
the pickup point offset here and register the corresponding part as a part to be
placed and then the offset is automatically applied to the pickup point so that it is
not necessary to teach the pickup point again.
In order to use this function, input the coordinates taught in the edit box.
X/Y
7-21
Part Registration
It is recommended to use X/Y without setting the offset.
Z
For parts fed by a tape feeder, it is recommended to set the Z value referring to
the following table.
<Flux Setting> group
In the case of flux part, it sets the method for part recognition. This function can
be used for the machine in which a flux device is installed.
<Type> combo box
No Flux
The POP function cannot be used for parts other than the flux part.
Post Flux
Recognizes the part after dipping it in the flux.
Pre Flux
Dips the part in the flux after recognizing it.
<Depth> edit box
Sets the Z axis height to the depth through which the part is dipped in the flux.
Set the depth with “0” as reference according to the characteristic of the part.
<Etc> group
<Dump Angle> combo box
For connectors or large parts such as large ICs, set the dump angle so that they
can be properly dumped into a dump box or tray pallet.
<Mount Method> combo box
Normal
Work on the parts normally
Virtual Pick
If selected, the placement is performed for the corresponding part with
picking up the actual part.
Tape Feeder
Tape Type
Z
8mm Paper PE Part Thickness
8mm Emboss -0.2
(Manual teaching for particular parts)
greater than
12mm
Emboss -0.2
(Manual teaching for particular parts)