2OM-1751-003w_G5S - 第103页
2OM-1751 1-51 [8] T ape Joint Detection One of the following buttons can be selected to determine whether or not an automatic teaching operation should be performed on the feeder pocket recognition after a tape joint lin…
2OM-1751
1-501303-001
[5] EP Data 1invalid set
Enable
When the number of handling errors reaches the value set in [4], the
production is stopped.
Disable
The EP data 1 count becomes invalid and the pick-up operation is continued
without stopping the production.
[6] Recog when Exceeding Pickup Diff
Enable
When this button is selected, the component recognition determination is
performed. When the component pickup difference is larger than the value
set in the "[7] Comp size setting", the pocket recognition is performed.
Disable
When this button is selected, the component recognition determination is not
performed.
[7] "Comp. size setting" Group Box
The allowance of the component pickup difference in above "[6] Comp.
Recog. Detn" is set in this text box.
Comp size 0603 and less
The component size smaller than that of 0603 component, is set in this text
box.
0603 < Comp size <= 1005
The component size larger than that of 0603 component and smaller than that
of 1005 component, is set in this text box.
Comp size 1608 and beyond
The component size larger than that of 1608 component, is set in this test
box.
4.2 "Opr.Mode" Tab Sheet
2OM-1751
1-51
[8] Tape Joint Detection
One of the following buttons can be selected to determine whether or not
an automatic teaching operation should be performed on the feeder pocket
recognition after a tape joint line has been detected.
Disable
Select this button not to perform an automatic teaching operation on the
feeder pocket recognition after a tape joint line has been detected.
Enable
Select this button to perform an automatic teaching operation on the feeder
pocket recognition after a tape joint line has been detected.
[9] Recog Interval at Joint
When the operation is re-started, the interval time is set up in this data box in
the case that the feeder pocket recognition automatic teaching is performed
periodically, based on the tape feeding times.
[10] Pocket Recog Start Pos
The pocket recognition starting position is setup in this data box.
[11] Pocket Recog End Pos
The pocket recognition ending position is setup in this data box.
[12] Joint recog judge by comp recog
"Enable" or "Disable" is selected for the spliced tape joint detection function
in this selection box.
Disable
It is selected when the joint detection is not used.
Enable
It is selected when the joint detection is to be used.
[13] Joint tolerance
The joint allowance is setup in this data box, in the case of using the "Joint
Recognition Judgment" function.
1303-001
4.2 "Opr.Mode" Tab Sheet
2OM-1751
1-521303-001
4.2 "Opr.Mode" Tab Sheet
[14] Poclet recog condition when restarting
The conditions for pocket recognition when the machine operation is re-
stared, are setup in this section.
Function Setting
"Enable" or "Disable" is selected for the pocket recognition condition in the
re-start operation, in this selection box.
Start condition
The time period from the machine stop (standby, stop or pause) mode to
machine operation start mode, is setup in this data box.
Recog Interval at Joint
The intervals for the automatic teaching to be performed periodically for the
feeder pocket recognition based on the number of tape feeding times when
the machine operation is re-started, are setup in this data box.
End condition (Interval)
The number of tape feeding times until the pocket recognition end, is setup
in this data box.