2OM-1751-003w_G5S - 第58页
2OM-1751 1-6 1303-001 [3] Production Data " Production Data " Window F2A5 PCB Process Time : Displays the time required to nish one PCB excluding the PCB in the middle of process. Displayed is the total time r…
2OM-1751
1-5
(2) Feeder Status
The current status of the feeder base is classied by color and
displayed. How to understand the status of each color is as follows.
Red
: There are some feeders of which pick-up rate is remarkably
dropped.
Yellow
: There are some feeders of which pick-up rate is dropped.
Green
: The pick-up condition is normal.
Gray
: It shows an unused feeder.
The component reload data for the corresponding feeder is displayed
in this section.
Green
: All feeders are normal.
Yellow
: There are some feeders for which the close attention is
required, such as the feeders with the component shortage
alarm.
Red
: There are some feeders which can not be used because of
component shortage or because the feeder has not been
installed.
Gray
: It shows an unused feeder.
(3) [Cover READY] Buttons
Using this button, the transparent cover lock/unlock status is displayed.
Reference
Refer to "2.3.1 Feeder Ready Switches and 2.3.2 Cover Lock
Switches" in "Chapter 1 (Vol. 1)" for the cover lock switches on the
main body of the machine.
(4) Product PCB Status
The PCB under placement is shown in dark green and the standby
PCB is shown in pale green.
1303-001
2.1 Local Window
2OM-1751
1-61303-001
[3] Production Data
"
Production Data
"
Window F2A5
PCB Process Time
: Displays the time required to nish
one PCB excluding the PCB in the
middle of process.
Displayed is the total time required
between the PCB receiving start and
the completion of the last component
placement.
Product PCB
: The number of produced unit PCBs
is displayed.
PCB Count
: The number of produced PCBs at
present is displayed.
Planned Product Count
: The No. of PCB products to be
produced is displayed in this data
box.
Production End Planned Time
: The PCB production end planned
time is displayed in this data box in
the case that the "Planned Product
Count" has been setup.
[Clear] Button
: When pressed, this button clears
the number of produced PCBs to
"0"(zero).
Reference
Refer to "8. "PCB.CNT" window" in "Chapter 6" for how to use the "PCB
Count".
2.1 Local Window
2OM-1751
1-71303-001
2.1 Local Window
[4] Data Display Section
The production data, component reload data and component handling rate
data parameters are displayed in this section. Each data display is changed
using the button on the lower right of the display section.
Production Data
When the display change button (left) is pressed, this window appears.
"Production Data" Window F2A6
Feeder Reload Data
The data of the feeder where the component replenishment is required, is
displayed.
"
Feeder Reload Data
"
Window F2A7