2OM-1751-003w_G5S - 第71页
2OM-1751 1-19 1303-001 4.1 "Run Mode" T ab Sheet [3] [1] [2] F2A16 [1] "Run Mode" Selection Buttons Press either one of the following buttons to select the desired run mode. [Place] Button : Select th…
2OM-1751
1-181303-001
4. "OPERATION" Window
The constraints based on the designation of any of the various operation modes in
the automatic operation and operation method in the test operation, are set in this
window.
[1]
F2A15
[1] Tabs and Tab Sheets
The "OPERATION" window is provided with the following four tabs. When
each tab is pressed, the corresponding tab sheet appears inside the window.
Tabs Description
Run Mode
The corresponding tab sheet enables the operator to change the
operation mode or stop the production.
Opr. Mode
The corresponding window enables the operator to select an operation
mode such as Over Tact-Time Reduction.
Test Mode
The corresponding window enables the operator to set test modes.
Altn Mode
The corresponding tab sheet enables the operator to set the "Feeder
Alternate"function.
T2A1
Graphic
Development
4. "OPERATION" Window
2OM-1751
1-191303-001
4.1 "Run Mode" Tab Sheet
[3]
[1]
[2]
F2A16
[1] "Run Mode" Selection Buttons
Press either one of the following buttons to select the desired run mode.
[Place] Button
: Select this button to set the machine in the "PLACE
(Automatic Operation)" mode.
[Pass] Button
: Select this button to set the machine in the "PASS" mode.
In the case that the pass operation has been setup, "PASS" is displayed in the
"Status Indicator" on the upper area of the "Product" window.
Status Indicator
F2A17
4.1 "Run Mode" Tab Sheet
Graphic
Development
2OM-1751
1-20
[2] "Start Mode" Selection Buttons
Using the following buttons, the start mode is setup.
[Auto] Button
Select this button to start up the machine automatically.
[Semi-Auto Step] Button
When this button is pressed, the designated step operation (one component/
point) is performed.
[Semi-Auto Any Desig] Button
When this button is pressed, the designated step operation (Designating two
or more steps is available) is performed.
[3] Cancel Run
When the [Cancel] button is pressed, the "Pause" condition is cancelled and
the machine is turned to the "STOP" mode.
Note
When the machine is set in the "PAUSE" mode by pressing the [STOP]
button on the operation panel during the automatic operation, etc., the
[Cancel] button becomes available.
1303-001
4.1 "Run Mode" Tab Sheet