00198171-02_Technical_Training_FSE_TX-Series_EN - 第83页
6 Conveyor System Room for Your Sketches and Notes Technical Training FSE SIPLACE TX-Series 01/2018 83 Room for Your Sketches and Notes
6 Conveyor System
6.8 Excercise: Conveyor System
82 Technical Training FSE SIPLACE TX-Series 01/2018
Maintenance content Interval Requirement
Clean the X-fiducial bar All workflows
●
Cleaning wipe
●
Protective gloves latex
TX micron 15μm:
Clean the -fiducial bar
All workflows
●
Cleaning wipe
●
Protective gloves latex
Lifting table statilizer Workflow 4
●
Ben 32
6.8 Excercise: Conveyor System
1. Which of the following statements is incorrect?
A Dual conveyor with outer fixed rail is the standard configuration for TX.
B Single conveyor is option for TX1.
C The conveyor system is controlled by two TSP420 control boards.
D The fixed rail is fixed by two screws, and it is possible to reconfigure.
2. What action is necessary after exchanging the lifting motor for TX?
A Adjust the belt tension for conveyor transport tooth belt.
B No action required.
C Calibrate the ZPC for the lifting motor.
D Calibrate the ZPC for lifting motor and the current value for lifting motor.
3. What needs to be calibrated after exchange of the vacuum tooling?
………………………………………………………………………………………………………
………………………………………………………………………………………………………
………………………………………………………………………………………………………
………………………………………………………………………………………………………
6 Conveyor System
Room for Your Sketches and Notes
Technical Training FSE SIPLACE TX-Series 01/2018 83
Room for Your Sketches and Notes
6 Conveyor System
Room for Your Sketches and Notes
84 Technical Training FSE SIPLACE TX-Series 01/2018