00198108-01_JC_PM_WF3_TX_EN.pdf - 第48页
14 WF 3 TX-Series Maintenance Check/ replace the vacuum pump filter disk 4 min 2 / 2 C A U T I O N ! R e f e r t o s a f e t y i n s t r u c t i o n s i n u s e r m a n u a l b e f o r e c o m m e n c i n g M a i n t e…
14 WF 3 TX-Series Maintenance Check/ replace the vacuum pump filter disk 4 min 1 / 2
CAUTION! Refer to safety instructions in user manual before commencing Maintenance
Machine Status OFF Conveyor Empty
NOTICE! ESD guidelines are to be followed Tool:
T31, T86
Wear Part: Consumables:
C19
www.asm-smt.com
1 Pump location. 2 Open panel. 3 Open the edgewise retaining clamp (1)
and remove cap.
4 Remove the vacuum filter. 5 Clean the vacuum filter. 6 If OK go to step 8.
14 WF 3 TX-Series Maintenance Check/ replace the vacuum pump filter disk 4 min 2 / 2
CAUTION! Refer to safety instructions in user manual before commencing Maintenance
Machine Status OFF Conveyor Empty
NOTICE! ESD guidelines are to be followed Tool:
T31, T86
Wear Part: Consumables:
C19
www.asm-smt.com
7 If NOT OK exchange filter. 8 Return the vacuum filter. 9 Lock the edgewise retaining clamp.
10 Close panel.
15 WF 3 TX-Series Maintenance Clean feeder modules and cut the tapes 3 min 1 / 1
CAUTION! Refer to safety instructions in user manual before commencing Maintenance
Machine Status OFF Conveyor Empty
NOTICE! ESD guidelines are to be followed Tool:
T1, T18
Wear Part: Consumables:
www.asm-smt.com
1 Vacuum all loose components from feeder
modules.
2 Cut the remaining tape directly at the
feeder.
3 After cutting: Ensure to leave 2 holes over-
lapping.
4 Repeat steps 1-3 for other feeder tables.