00198371-01_UM_SWS-EN - 第30页
1 Introduction User manual SIPLACE Wafer System (SWS) 1.4 Operator levels Edition 04/2018 30 1.4 Operator levels Certain functions or menus m ay only be ex ecuted or accessed by specially trained person nel. A differe nt…
User manual SIPLACE Wafer System (SWS) 1 Introduction
Edition 04/2018 1.3 Qualification and training of personnel
29
1.3 Qualification and training of personnel
Personnel used for operation, preventive maintenance, inspection and installation must hold the
relevant qualifications for the job. The user must keep tight control over their responsibilities, as-
signment and supervision. Any employee who does not have the relevant training must be trained
and given appropriate instruction. The instruction is to be given by trained and authorized person-
nel.
1
PLEASE NOTE
Operation of system only by qualified personnel
Only appropriately qualified staff may start up, operate or otherwise work on the ma-
chine.
The qualification must be proven by means of training courses or instruction for the per-
sonnel.
1 Introduction User manual SIPLACE Wafer System (SWS)
1.4 Operator levels Edition 04/2018
30
1.4 Operator levels
Certain functions or menus may only be executed or accessed by specially trained personnel. A
differentiation is made between the following operator levels:
– Production
– Advanced production
–Service
The operator levels "Advanced production" and "Service" can be password protected.
Production
This operator level includes those people who have been trained to operate the machine. These
people are authorized to use any functions associated with operating the machine and may call
up any menus needed to use the machine.
Advanced production
People with this operator level have completed special training and are authorized to perform
setup tasks e.g. creating setup configurations or determining Vision parameters etc.
Machine service
People with this operator level are specially trained technicians at the customer end, who can, for
example, define machine option settings.
User manual SIPLACE Wafer System (SWS) 1 Introduction
Edition 04/2018 1.5 Important notes on the user manual
31
1.5 Important notes on the user manual
1.5.1 Contents and storage of the user manual
This user manual contains basic information that must be observed when setting up, operating
and maintaining the SIPLACE Wafer System. The service engineers, qualified staff, operators and
users plus system owner must therefore read it before commencing installation and commission-
ing. The instructions must be kept permanently accessible where the SIPLACE Wafer System is
used.
In addition, the user must ensure that the employees have fully understood the contents of the
user manual.
1.5.2 Danger notes
1
1.5.3 Manufacturer's/supplier's liability
We hereby confirm that the contents of this user manual are of a descriptive and explanatory na-
ture only and do not contain any contractual conditions or guaranties. The liability and obligations
assumed by ASM Assembly Systems GmbH&Co.KG can be found exclusively in the relevant
contract agreement concerning the supply of the machine described in this manual. This applies
in particular to all statements regarding performance or service life and the agreed liability for
faults or defects. The provisions of the contract regarding the liability for faults or defect are neither
extended nor restricted by any statements in this user manual.
WARNING
Read the user manual!
Tasks may only be performed by qualified staff who have completed the relevant
training.
Only perform tasks on the SIPLACE Wafer System if you have precise knowledge
of the relevant section in the user manual.
Observe all warnings, caution notes and hazard notes.
Please also read chapter 2 of this user manual through carefully.