00198371-01_UM_SWS-EN - 第87页

User manual SIPLACE Wafer System (SWS) 4 Setting up and commissioning Edition 04/2018 4.2 Infrastructure a t the installation location 87 4.2 Infrastructure at the inst allation location For det ails, see the user manual…

4 Setting up and commissioning User manual SIPLACE Wafer System (SWS)

4.1 Delivery configuration and transportation of SWS Edition 04/2018

4.1.3.3 Fork lift attachment points on the SWS

. 4

Fig. 4.1 - 2 Attachment points for fork-lift or hand lift on SWS

4.1.3.4 Points to be observed while transporting the SWS

WARNING

 Only lift the SWS by its metal frame.

WARNING

Center of gravity for the SWS

 Keep an eye on the SWS center of gravity (see section 3.2.6), particularly when mov-

ing it sideways.

User manual SIPLACE Wafer System (SWS) 4 Setting up and commissioning

Edition 04/2018 4.2 Infrastructure at the installation location

4.2 Infrastructure at the installation location

For details, see the user manual for the SIPLACE CA4 V2, German [item no.: 00198381-xx], En-

glish [0198382-xx].

4.2.1 Weight and surface load

The machine weight values can be found in section 3.2.5, page 63.

4.2.2 Compressed air supply to SWS

The compressed air supply to the SWS is provided directly from the SIPLACE CA4 V2.

4.2.3 Mains power supply to the SWS

4.2.3.1 Danger notes

PLEASE NOTE

Also observe the document "Network and compressed air configuration for SMD sys-

tems" (German+English, item no. 00197548-xx), supplied to you on delivery.

DANGER

Dangerous voltage levels!

The SIPLACE Wafer System is supplied with 3 x 380 V~ to 3 x 415 V ± 10 %, 50/60 Hz

or optionally with 3 x 200 V~ to 3 x 340 V~ ± 10 %; 50/60 Hz mains voltage. This means

that some parts of the system carry potentially lethal voltages - even when switched off at

the main power switch and with disconnected mains plug.

Incorrect handling of the SIPLACE Wafer System can therefore result in death or severe

injury or considerable damage to equipment.

 Always follow the applicable accident prevention and DIN regulations (particularly EN

60204, part 1 or IEC 60204, part 1) and the applicable regulations in your own coun-

try.

 The covers over the power supply unit may ONLY be opened by appropriately quali-

fied and trained personnel.

4 Setting up and commissioning User manual SIPLACE Wafer System (SWS)

4.2 Infrastructure at the installation location Edition 04/2018

4.2.3.2 Checking the mains power supply

Check whether the power supply complies with the prescribed machine specifications (see table

in section 3.2.3

, page 62).

DANGER

Lethal voltages under the safety cutoff (CSB) cover!

Under the cover there are components which could still carry lethal voltages, even when

the machine is switched off and the mains plug has been disconnected. After disconnect-

ing the mains plug, wait 5 minutes until the capacitors have discharged.

 Never open the covers.

 Only ASM Assembly Systems GmbH&Co.KG service engineers or the machine

owner's service engineers, who have been trained by ASM, may perform work on the

power supply and the safety cutoff (CBS).

PLEASE NOTE

Load peaks in power supply

For technical reasons, load peaks occur in the power supply.

 Please contact your power company to clarify the mains impedance, if necessary.