OPERATING MANAUAL(FOR ENGINEERS) - 第155页
Page 8-1 3Y3C-E-EMD08-A01-00 Chapter 8 MACHINE SETTING MACHINE SETTING Machine setting That state of machine independent of production data can be set. 8-1 Adjustment switch Condition of producing can be temporally chang…
Page 7-10
Recognition Unit Maintenance
7-8-1 Recognition Unit Update
This section describes updating the recognition system.
Copy the recognition system from the floppy disk with recognition system to be upgraded to RAM,
and after comparing (inspecting by reading) the system of floppy disk with that of RAM, the system
is written to the memory if no trouble is found.
<Description of Items>
ROM version : Current recognition ROM version
System version : Version of recognition system to upload
All blocks : Current recognition system volume
Transferring blocks : Transferred recognition system volume
∗ Refer to “Chapter 4 UPDATING” in the Maintenance Manual for the details.
3Y3C-E-EMD07-A01-01
Page 8-1
3Y3C-E-EMD08-A01-00
Chapter 8
MACHINE SETTING
MACHINE SETTING
Machine setting
That state of machine independent of production data can be set.
8-1 Adjustment switch
Condition of producing can be temporally changed for adjustment.
8-2 Pickup posn learning
Corrected value by pickup position learning in producing can be checked for each feeder address.
8-3 Bad head
Each head and nozzle for it can be checked.
8-4 Time set
Time for machine can be set.
8-5 Speed set
The speed in producing can be temporally changed for adjustment.
8-6 Customizing Operator mode
You can set the functions which were available only in the engineer mode, to us in the operator
mode.
Page 8-2
3Y3C-E-EMD08-A01-00
8-1 Adjustment Switch
The condition of producing can be temporally changed for adjustment.
The figure below is the main axis and transfer head viewed from the top. Usually, all items except
Simulate mode are turned on.
Pressing Default or restarting returns the setting to normal operation.
Chip feeding
Tape of feeder is fed by ON.
Pickup
Pickup is started by ON.
Detect chip thick
Chip height is detected and error is checked by ON.
Chip recognition
Chip is recognized and error is checked by ON.
Mount
Mounting starts by ON.
Recovery
Chips of pickup fault, non-level chip fault, recognition fault are picked up again.
Simulate mode
Production data is operated repeatedly by ON.
Extend conv W adj
Width of extension conveyor is automatically adjusted by ON. When the conveyor is not
connected properly, it is forced to be OFF.