OPERATING MANAUAL(FOR ENGINEERS) - 第57页
Page 2-1 3Y3C-E-EMD02-A01-00 Chapter 2 BASIC OPERATION BASIC OPERATION Engineer Mode T o prevent mal-operation, the touch panel has two modes, for an operator and an engineer , according to use. This section describes th…
Page 1-20
3Y3C-E-EMD01-A01-01
3Y3C-044E
smetI liateD
royevnocnoisnetxE
dnaezisMrof:88MCrofroyevnocnoisnetxefosezisowteraerehT
naotdelpuocsienihcamsihtnehw,ezisMehtrofsA.ezisDrof
enihcamehtneewtebroyevnocnoisnetxena,resnepsidevisehda
.yrassecentonsiresnepsidehtdna
elzzonfleM
.spihcfleMrofylnoelzzonehT
,elzzondradnatsgnisuybdetnuomebnacyehT
.elzzonfleMgnisuybretsafdetnuomebnacyehttub
GIJecnanetniamredeeF
klubdnaepatfonoitidnocehtgnipeekrofgijecnanetniamehT
.semitllatamumitposredeef
dnatsredeefepaT
∗ PSCstroppuS
ehtniPSCdnaAGBfonoitingoceredortceleehtrofderiuqertinU
mm7foegnar × mm51otmm7 × mm51
∗ gijtesffonoitisopnoitcuS
elzzondaeh21ehtfonoitarbilacroF
∗ gijtesffonoitisopgnitnuoM
noisicerpgnitnuomehtfonoitarbilacroF
∗ elzzondetpoda-3060
pihc3060ehttnuomotelzzonehT
4G3C-202TE
4G3C-204E
Direction of PCB motion
Front extension
convyor
Rear extension
convyer
(unit: mm)
Major Option
Tape width
8 mm ~ 32 mm paper/embossed (except adh.)
Applicable feeders
E9, C9 type tape feeder
BF type bulk feeder
4G3C-206E
4G3C-205E
ø1.3
ø0.9
(unit: mm)
Coupler : 20PF
Made by Nittoh Kohki
Camera
(for checking pick-up position)
Pick-up position
dummy JIG
Cylinder height gage
Master JIG
Monitor
Power supply : AC 100 V
∗ Only for CM88S
1,100 1,100
Page 2-1
3Y3C-E-EMD02-A01-00
Chapter 2
BASIC OPERATION
BASIC OPERATION
Engineer Mode
To prevent mal-operation, the touch panel has two modes, for an operator and an
engineer, according to use.
This section describes the main menu for the engineer mode.
(For the menu and operation switches at the lower part of screen for operator mode,
see the manual for operator.)
Main menu for engineer mode
Page 2-2
3Y3C-E-EMD02-A01-00
2-1 Functions of the Engineer Mode
2-1-1 Starting the Engineer Mode
∗ Password must be entered to start the engineer mode. When the password has not been set,
refer to “2-1-4 Changing the Password,” and set it.
1. Press
Engineer
.
• The password input screen appears.
2. Enter the password, and press
Decision .
• The main menu for engineer mode appears.
∗ For fault input, press BS key and reenter.
3Y3C-EOP-Main-001
2
1