DECAN_S1_Operation_EN.pdf - 第77页
Ch e ck o th e r s and r e plac e e xhaus t e d part s Chap ter 6 Nex t Generation, Multi- Funct ional Placer DE CAN S 1 Ope ra tio n Han db oo k 6-4 This Chapter describes the items for which care must be exercised whil…
Check others and replace exhausted parts
Chapter 6
Next Generation, Multi-Functional Placer
DECAN S1 Operation Handbook
6-3
This Chapter describes the items for which care must be exercised while
using thetape feeder as well as the method to take measures when
parts are exhausted.
Checking Feeder > Checking part reel (Pneumatically Driven)
Checking Feeder
3. Checking part reel (Pneumatically Driven)
Pass the tape through groove A, B as shown in the figure below.
Caution
If the part reel is not mounted as in the figure, index error may
occur.
ㆍ The tape should extend more than 100 mm from the part adhesion point.
ㆍ The vinyl should extend more than 50 mm from the center of the drain gear.
Check others and replace exhausted parts
Chapter 6
Next Generation, Multi-Functional Placer
DECAN S1 Operation Handbook
6-4
This Chapter describes the items for which care must be exercised while
using thetape feeder as well as the method to take measures when
parts are exhausted.
Checking Feeder > Checking part reel (Electrically Driven)
Checking Feeder
Check others and replace exhausted parts
4. Checking part reel (Electrically Driven)
Pass the tape through groove A, B, C as shown in the figure below.
Caution
If the length from the pickup point of the carrier tape to the front
end of the tape is short, problems including tape jamming may
occur. Therefore, use tape long enough to pass the curved section
as shown in Figure D.
Check others and replace exhausted parts
Chapter 6
Next Generation, Multi-Functional Placer
DECAN S1 Operation Handbook
6-5
This Chapter describes the items for which care must be exercised while
using thetape feeder as well as the method to take measures when
parts are exhausted.
Checking Feeder > Checking locker
Checking Feeder
5. Checking locker
Check Points
ㆍ After mounting the part reel on the feeder, make sure the locker
is properly locked.
Caution
If the tape guide and the locker are not locked properly, it may
collide with the head during operation.